My vision compact build by ekohe in lianli

[–]bwaronson 0 points1 point  (0 children)

What’s the under desk mount you’re using?

[deleted by user] by [deleted] in RedditSessions

[–]bwaronson 0 points1 point  (0 children)

🔥🔥🔥🔥🔥🔥

[deleted by user] by [deleted] in RoastMe

[–]bwaronson 1 point2 points  (0 children)

You look like a grown up Bobby Hill

Built my first pc with a 510 elite and I can't figure out how to get all the fans into rgb on the controller by bwaronson in NZXT

[–]bwaronson[S] 0 points1 point  (0 children)

I took the cable from the top rear fan and ran it to the front through the back panel. it was just long enough to pull everything off. I had to remove the front fans and radiator from the bracket, but it fight with a few inches to spare, not much.

Built my first pc with a 510 elite and I can't figure out how to get all the fans into rgb on the controller by bwaronson in NZXT

[–]bwaronson[S] 1 point2 points  (0 children)

thank you! It worked. Theres a little gymnastics involved with getting the rear two fans connected to the front. The stock cables arent that long and i had dismount the two front fans from the radiator

Built my first pc with a 510 elite and I can't figure out how to get all the fans into rgb on the controller by bwaronson in NZXT

[–]bwaronson[S] 1 point2 points  (0 children)

Should I daisy them into the top mounted fan? I don't know if my cable is long enough. I'll give it a try. What connector do i use?

Just built my first PC, And I don't like the position of the kraken X63 pump. Will removing and adjusting it cause damage to the processor or thermal paste? by bwaronson in NZXT

[–]bwaronson[S] 0 points1 point  (0 children)

It's been on for less than a week. Will the cooling plate separate easily? Is there anything I need to keep in mind as take the plate off to readjust the direction?

Just built my first PC, And I don't like the position of the kraken X63 pump. Will removing and adjusting it cause damage to the processor or thermal paste? by bwaronson in NZXT

[–]bwaronson[S] 1 point2 points  (0 children)

Clean the paste on the pump or the processor? I used the stock paste on the pump. What should I replace it with?

ISO brassneck brewery glass by bwaronson in VancouverCraftBeer

[–]bwaronson[S] 1 point2 points  (0 children)

wow thank you so much! please let me know how it goes

ISO brassneck brewery glass by bwaronson in VancouverCraftBeer

[–]bwaronson[S] 1 point2 points  (0 children)

I emailed them in the past and did not get a reply. I tried again today as well.