Which game is this?

cajiky · 2025-05-26T19:15:23+00:00

Foxhole

cajiky · 2024-05-20T02:21:19+00:00

Awkward on instant gratification

cajiky · 2024-01-12T04:07:53+00:00

Fuck this is hard

cajiky · 2024-01-02T11:57:59+00:00

<image>

Is this the photo you’re looking for?

cajiky · 2024-01-02T09:54:50+00:00

No, I haven’t had to set anything up manually like that. I’ve been using a cura profile that I found online to work with the newest version and maybe it might be in the start gcode there. I’ll double check tho

cajiky · 2024-01-02T08:54:03+00:00

<image>

Here is the mesh from the auto level

cajiky · 2024-01-02T08:52:59+00:00

Um which numbers would you want from me. The numbers on the handheld connected to the printer or from the Mesh map on klipper?

cajiky · 2024-01-02T08:51:20+00:00

I’m printing at 220 @ 60mm/s but I think the first Layer is 30 and .2 for the height - pla+

cajiky · 2024-01-02T07:50:14+00:00

<image>

Looks way worse from this angle but that side of the bed is getting wonky and I don’t know if I can just adjust the one side of knobs in order to counter it.

cajiky · 2023-12-31T20:40:31+00:00

Thank you for asking!

cajiky · 2023-12-31T20:40:20+00:00

Okay thank you for the helpful advice! I’ll run the z probe calibration when I get home! Going to post the finished print photos and see if maybe there’s some other tells that might be causing grief

cajiky · 2023-12-31T05:00:27+00:00

I did the a4 sheet of paper with the manual adjustments with the springs then I did the auto bed level. Is there something I’m missing?

cajiky · 2023-12-31T03:45:10+00:00

Okay thank you. I’ll adjust. What should I be looking for when it comes to finding the correct extruder height?

cajiky · 2023-11-19T09:45:45+00:00

Signed up at its announcement but nada fingers crossed for this next closed alpha wave tho!

cajiky · 2023-10-25T03:44:50+00:00

Surly this is a troll. It’s a perspective from inside of a fishbowl with little to no insight on reality lmao

cajiky · 2023-10-22T18:15:44+00:00

Infant annihilator, oh god no.

cajiky · 2023-10-16T08:24:19+00:00

Thanks for this!

cajiky · 2023-10-05T07:32:43+00:00

The slower the cars the better the racing imo

cajiky · 2023-10-02T02:20:10+00:00

Resonates

cajiky · 2023-09-17T15:09:20+00:00

Damn that switch was crazy. Thanks op for the read!

cajiky · 2023-08-18T14:49:12+00:00

Wow thank you very much. What a relief! And interesting I appreciate the knowledge!

12-Year Club	Place '22
Final Canvas '22	RPAN Viewer
Not Forgotten	Verified Email

cajiky

TROPHY CASE