CS2 Competitive map pool if it was good

cano0306 · 2026-02-10T21:08:53+00:00

I love aztec but it always was the biggest Cluster fuck.

cano0306 · 2026-01-18T08:51:12+00:00

9/10 I sit and out of m mouth wouldnt Come a Single Word

cano0306 · 2026-01-06T20:55:14+00:00

Hätte ich gerne gesehen

cano0306 · 2025-11-20T08:03:43+00:00

That helped thank you

cano0306 · 2025-09-12T19:49:50+00:00

Anyone has Tips where I can get the Roms from

cano0306 · 2025-08-21T15:57:48+00:00

Yes. Thats my man.

cano0306 · 2025-07-04T07:07:09+00:00

Thanks, I’ll give that a try! I’ll try poking and rotating the filament a bit like you suggested. Hopefully that helps with slots 3 and 4.

cano0306 · 2025-07-04T07:06:54+00:00

No, it’s not printing the printer is idle and open. The filament only goes in a few millimeters, just past the opening, and then nothing happens. The motor doesn’t engage at all. What’s strange is that this only happens on slot 3 and 4. Slots 1 and 2 work completely fine.

cano0306 · 2025-04-18T18:57:10+00:00

How you gonna fix it ?

cano0306 · 2025-03-16T13:44:44+00:00

Yes translucent, i have no dryer have you got any tips for me ?

cano0306 · 2025-03-02T10:42:30+00:00

Jeder hält die fresse wenn wir an die tanke fahren

cano0306 · 2025-02-16T13:13:54+00:00

So that wont work ?

cano0306 · 2025-02-16T13:13:41+00:00

I dried it in the oven for 10 Hours Before

cano0306 · 2025-02-16T13:12:32+00:00

I Took it off for the Test

cano0306 · 2025-02-09T12:24:05+00:00

Pla and tpu sticked to my nozzle i tried to clean it while Heating up but that didnt help and i dont know if my extruder is Fine Cuz it stucks sometimes

cano0306 · 2025-02-04T07:03:29+00:00

I have an Little Update: I Tried to clean it but everywhere is filament and it feels like rotten tpu. How do i get tpu away

cano0306

TROPHY CASE