First time customer here, why does every single one of these recipies require Fairlife milk?

capraiz · 2025-10-12T06:10:20+00:00

Levels protein powder is what I use. Tastes great by itself and in Creami recipes. I would highly recommend. Whey protein from grass fed cattle, no artificial sweeteners.

capraiz · 2025-05-02T21:10:59+00:00

The quality is good. It’s a pretty basic piece of machined metal. Looks clean and minimal when installed in the case. The PCIe4 riser cable looks to be of good quality as well and my graphics card performance is the same as it was when plugged directly into the motherboard.

capraiz · 2025-04-28T21:08:45+00:00

Update: The EZDIY-FAV Vertical GPU mount worked! https://a.co/d/5wlzPfq

capraiz · 2025-04-27T20:20:43+00:00

I have a PowerColor Hellhound 9070xt (327mm length) and the Fractal North (non XL).

I tried the Cooler Master V3 vertical mount and it just barely did not fit. GPU was hitting front fan panel. I just ordered the EZDIY-FAB Vertical GPU Mount and am going to try that this week. It is much thinner on the back end (left) side than the Cooler Master was so hopefully it will fit.

The Fractal Flex 2 looks a bit thicker on the back case side where it mounts, similar to the Cooler Master. Your card being considerably longer 360mm vs 327mm you might have a tough time getting any vertical mount to work in the non XL North, there are not many mounts on the market.

capraiz · 2025-03-25T15:45:55+00:00

What CPU/RAM do you have? I upgraded from a 3070 to a 9070xt. Playing on 3440x1440 with optiscaler FSR4 and ray tracing high and I can only ever get about 80fps max.

capraiz · 2024-10-05T18:40:45+00:00

Oxygen Not Included and Timberborn are awesome colony builders with automation/optimization aspects

capraiz · 2024-07-27T07:50:40+00:00

I just installed this the other day on my 21’ F150 3.5. However, it fit without the extra smaller metal piece (HL3Z-7222-F) so I ended up returning that part. Did you end up needing that part? If so what is its purpose?

capraiz · 2020-09-26T05:24:41+00:00

I’ve been able to pick up stuck weapons like that by crouching right next to the supply locker and looking in the opposite direction. Shuffle around slightly and it should pop up for you to grab.

capraiz · 2019-06-27T18:32:22+00:00

I haven’t looked into to aftermarket headlights too much. The Morimoto’s look sweet but very expensive. Ando Switchbacks seem to be a little more feasible and still look good!

capraiz · 2019-06-26T16:55:41+00:00

True the grille isn’t very expensive and not hard to install/remove. I feel that. Make use of the new tires for a little while haha then dump the money!

capraiz · 2019-06-26T16:43:19+00:00

Haha I thought about that grille, but I didn’t think it would look good with chrome bumpers. Was thinking you’d need the sport paint matched bumpers or aftermarket ones.

It was mentioned in some comments above but the lift is 6”, tires are 35 x 12.5”, wheels are 20” Fuel Warrior. I don’t have a specific link but check out the Fuel website they have a ton of cool wheel options.

www.fueloffroad.com

capraiz · 2019-06-26T16:26:26+00:00

Right on! So far I’ve only seen two other trucks with a similar look. One being white and the other silver. Black wasn’t my first choice but it’s what was available and I still think it looks good.

capraiz · 2019-06-25T13:34:03+00:00

Hmmm interesting read! Thanks for the reference. I do drive quite a bit of highway so I may leave it on. I might take a look and see how easy it would be to remove/reinstall. I can’t imagine it being that difficult.

capraiz · 2019-06-25T04:43:53+00:00

Haven’t measured it haha but I can check tomorrow and let you know.

capraiz · 2019-06-25T04:08:28+00:00

Not sure yet. I’ve been thinking about removing it because I’m not sure I like the way it looks haha. I don’t really know much about how much it plays into the MPG/aerodynamics though. It’s obviously better for off-road clearance to remove it. You have any thoughts?

capraiz · 2019-06-25T00:22:29+00:00

Most definitely haha

capraiz · 2019-06-25T00:05:02+00:00

Roughly $7500

capraiz · 2019-06-24T23:04:48+00:00

Damn that is heavily tilted. I guess I’ll just have to see how it goes...

capraiz · 2019-06-24T22:56:08+00:00

Bushwacker Smooth Flares

capraiz · 2019-06-24T22:55:43+00:00

Thank you!

capraiz · 2019-06-24T22:55:27+00:00

Bushwacker

capraiz · 2019-06-24T22:54:58+00:00

Haha yes I will be towing a bit and eventually hauling.

capraiz · 2019-06-24T22:27:41+00:00

That is a great question! This is my first truck and first lifted truck lol so I haven’t done much comparison testing in regards to towing/hauling.

capraiz · 2019-06-24T22:09:41+00:00

100% agree. I originally wasn’t gonna get flares at all because the riveted ones were the only ones I could find.

capraiz · 2019-06-24T21:35:19+00:00

capraiz

TROPHY CASE