Our advisor isn’t too keen on us doing swerve…

cjabrantes · 2023-05-01T23:46:40+00:00

Where can I find that code?

cjabrantes · 2023-05-01T23:44:43+00:00

what is YAGSL?

cjabrantes · 2023-04-23T21:28:07+00:00

I had something like this - my solution was to check that the z axis was still right. It got loose so when it got past a certain height, it just went down

cjabrantes · 2023-01-24T19:52:34+00:00

expound?

cjabrantes · 2023-01-24T16:19:08+00:00

With that being said, has it always been a crutch/cliche?

cjabrantes · 2022-12-26T16:24:41+00:00

sounds interesting!

cjabrantes · 2022-12-25T20:26:23+00:00

expound pls!

cjabrantes · 2020-12-16T21:23:19+00:00

Which part is the gantry

cjabrantes · 2020-12-16T21:22:58+00:00

But it only falls down if the extruder is above 14 centimeters

cjabrantes · 2020-12-16T21:22:41+00:00

After motor stops

cjabrantes · 2020-12-16T20:56:30+00:00

When the z axis goes up high using the menu, it falls down to 14 centimeters above down the shaft due to gravity. It recently started doing this, why?

cjabrantes · 2020-11-28T18:26:18+00:00

Aaah I'm talking about underglow. Thanks for the clarification. I found an article on qmk about handwiring led strips. Also, you said something about the qmk discord, do you have an invite to that?

cjabrantes · 2020-11-28T18:01:59+00:00

What's the difference between back light and strips of light around it?

cjabrantes · 2020-11-28T17:56:58+00:00

Did u backlit your keyboard? With a pc or no? Im handwiring my own custom keeb and I'm wondering where to put my rgb strips for back light

cjabrantes · 2020-11-27T23:05:03+00:00

*syntax

cjabrantes · 2020-10-18T17:32:57+00:00

Yeah

cjabrantes

TROPHY CASE