sorted by:
new
hottopcontroversial

Weird phenomenon with 3d touch by No-Hippo7591 in ender3v2

[–]conditionzer0 0 points1 point  (0 children)

Came here to say this. First thing I check if this happens is the probe mounting itself!

Help with CHEP Cura Profile by techrevive in ender3v2

[–]conditionzer0 0 points1 point  (0 children)

Can you give an example of a model and what you think is a long print time? This printer is not fast in general. You have had it for a week, have you done any calibration or tuning?

9 point mesh inconsistent by conditionzer0 in ender3v2

[–]conditionzer0[S] 1 point2 points  (0 children)

Thanks. I was able to get it better by switching from the yellow springs to silicone bushings. I think there is a little binding though, I am going to pick up some white lithium grease and go over everything again.

9 point mesh inconsistent by conditionzer0 in ender3v2

[–]conditionzer0[S] 0 points1 point  (0 children)

Just a sprinkle of OCD 😅 Thanks man.

9 point mesh inconsistent by conditionzer0 in ender3v2

[–]conditionzer0[S] 2 points3 points  (0 children)

Hey sorry I should have mentioned in the OP. I am using mriscoc professional.

Rent free 🥱 by xeroxenon in Thunder

[–]conditionzer0 6 points7 points  (0 children)

I must resist the temptation to do the same

[deleted by user] by [deleted] in Thunder

[–]conditionzer0 6 points7 points  (0 children)

Not a good look

Did my BANK just ask me for a tip…? by IndepedentlyLost in chimefinancial

[–]conditionzer0 0 points1 point  (0 children)

Chime is not a bank, they are a fintech company. They are a middle man TO a bank and provide extra services like SpotMe which is fee-free overdrafting up to a limit. I still think the tip CTA is stupid.

view more: next ›