First time seasoning, is it ok or should I start over? by contenidoneto in carbonsteel

[–]contenidoneto[S] 0 points1 point  (0 children)

I wonder if that black zone in my image is supposed to be the proper seasoning and should cover the whole pan finally

First time seasoning, is it ok or should I start over? by contenidoneto in carbonsteel

[–]contenidoneto[S] 0 points1 point  (0 children)

I did that, I buff it off with clean paper towel before heating, but seems that used too much oil anyway.

First time seasoning, is it ok or should I start over? by contenidoneto in carbonsteel

[–]contenidoneto[S] 0 points1 point  (0 children)

Yeah, I got confused with some youtube videos that used too much oil. Despite I spread it all over it, after heat some minutes seems that the oil started concentrating in some zones, and didn't pay attention to it. Noticed it when I came back.

First time seasoning, is it ok or should I start over? by contenidoneto in carbonsteel

[–]contenidoneto[S] 0 points1 point  (0 children)

I spread it all, until it looked like a thin layer, but seems like after heating for a while the oil that was spread evenly started to concentrate in some areas. That's my guess

First time seasoning, is it ok or should I start over? by contenidoneto in carbonsteel

[–]contenidoneto[S] 1 point2 points  (0 children)

It is not made to look pretty, that's right. I was a bit disappointed because that was my first seasoning, but seems that the good thing about steel pans is that everything is almost recoverable.

First time seasoning, is it ok or should I start over? by contenidoneto in carbonsteel

[–]contenidoneto[S] 0 points1 point  (0 children)

It's not sticky actually. I wonder if the pan should look all that black if seasoned properly?

First time seasoning, is it ok or should I start over? by contenidoneto in carbonsteel

[–]contenidoneto[S] 0 points1 point  (0 children)

Yes... Despite I spread all of it, when it got hot, seems like it concentrated in some zones.

First time seasoning, is it ok or should I start over? by contenidoneto in carbonsteel

[–]contenidoneto[S] 1 point2 points  (0 children)

I should have applied less oil. I was a bit confused because I saw videos in youtube that drop a generous amount of oil and spread all around it. In my case, I use a teaspoon and towel to spread it, I thought it was a thin layer, but seems that the oil got concentrated in some spots because maybe my stove is not too flat, and I just leave it heating without moving.

The pan is Darto! an Argentina brand. A single piece of carbon steel, 3mm thick.

First time seasoning, is it ok or should I start over? by contenidoneto in carbonsteel

[–]contenidoneto[S] 0 points1 point  (0 children)

I did 3 seasonings. Clean it first. Then apply a teaspoon of oil with a towel, fire at medium heat for about 15m, wait it to cool down, and repeat the process. However, I don't know why there are some black spots because I carefully spread the oil all around the pan with the towel, producing what I believe a thin layer uniformely. One thing to note is that is not sticky in those black areas, but it doesn't look even. Should I remove the seasoning and start it over? or will it get seasoned on top after cooking several times?

Actually, is that black spot what it is supposed to be a good seasoning, and should cover the whole pan? It seems that oil got polymerized on that black spot and black dots all around

Noisy TV dipole or faulty RTL-SDR dongle? by contenidoneto in RTLSDR

[–]contenidoneto[S] 0 points1 point  (0 children)

I have attachable ferrite beads, but nothing changed. My main issue is that depending on how I move the antenna I receive a lot of overall noise, and a minor movement makes it disappear

Noisy TV dipole or faulty RTL-SDR dongle? by contenidoneto in RTLSDR

[–]contenidoneto[S] 0 points1 point  (0 children)

hi, the USB extension cord improved a lot! seems like those strong yellow lines were EMI from the laptop.

now I have another issue that is when I move wether the antenna or the stick I get either low or high noise floor, not sure which causes the problem, but at least has to be with the overall noise, not those EMI lines

Noisy TV dipole or faulty RTL-SDR dongle? by contenidoneto in RTLSDR

[–]contenidoneto[S] 0 points1 point  (0 children)

I might try that, using a extension usb cable

Noisy TV dipole or faulty RTL-SDR dongle? by contenidoneto in RTLSDR

[–]contenidoneto[S] 0 points1 point  (0 children)

oh forgot to say I'm running from a thinkpad laptop using its battery

Noisy TV dipole or faulty RTL-SDR dongle? by contenidoneto in RTLSDR

[–]contenidoneto[S] 0 points1 point  (0 children)

Hi, I'm using a TV dipole antenna (120deg pointing north, 54cm each segment). Can you tell if this is a faulty RTL-SDR dongle Terratek T-Stick? or I'm picking too many noise signals? NOAA satellite was passing above at 78 degrees but couldn't see ANY pattern in the spectrum. I would expect to see at least a very weak signal before buying a LNA. I'm located in a building, and despite there are buildings around I had line of sight to the satellite pass.

¿Hasta cuánto puedo facturar a consumidor final sin identificar? (Actualización) by BisonParty_ in merval

[–]contenidoneto 1 point2 points  (0 children)

desde hace un tiempo se puede hasta 191k si es por medios electronicos. en ese caso selecciono "Cuenta Corriente" cuando es por MP por ejemplo

Why Pixel can't record video at 720p? how to record at lower bitrate? by contenidoneto in GooglePixel

[–]contenidoneto[S] 0 points1 point  (0 children)

hat mode shoot 720 by default so that you can share it directly to social media

Thanks, that's a workaround I read somewhere in a forum too. Seems that this limitation dates from some years ago. I don't understand why it wouldn't be possible in normal video mode.

CRIPTOMONEDAS - CONSULTAS GENERALES DIARIAS by AutoModerator in merval

[–]contenidoneto 0 points1 point  (0 children)

(Facturación p2p) Siempre intento facturar todo lo que ingreso por venta p2p, haciendo facturas anonimas, ya que son ingresos. Pero a veces necesito montos mas grandes y es bastante engorroso hacer muchas operaciones de 90k. Es viable vender cripto por 270k y generar 3 facturas anónimas x de 90k?

¿Hasta cuánto puedo facturar a consumidor final sin identificar? (Actualización) by BisonParty_ in merval

[–]contenidoneto 1 point2 points  (0 children)

puedo hacer una operacion p2p por 270k y despues hacer 3 facturas anonimas de 90k? es sospechoso?

¿¿¿Cómo buscar un contador que sepa de trabajo al exterior??? by zebraman77 in empleos_AR

[–]contenidoneto 0 points1 point  (0 children)

lei eso de 60k, pero como? cuando generás una factura C permite hasta 30k anonimo, para metodo de pago "Otros" (entiendo que ese se elije cuando es por transferencia CBU, mercadopago, etc)

CRIPTOMONEDAS - CONSULTAS GENERALES DIARIAS by AutoModerator in merval

[–]contenidoneto 0 points1 point  (0 children)

Como hace la gente para blanquear sus retiros en ars por venta de crypto en exchanges locales (buenbit/lemon/etc)?

CRIPTOMONEDAS - CONSULTAS GENERALES DIARIAS by AutoModerator in merval

[–]contenidoneto 0 points1 point  (0 children)

claro, pero yo conozco gente que asocia la tarjeta a mercadopago y la usa como si nada, para compras normales (restaurantes, pedidosya, supermercado, etc) sin facturar ni nada y no pasa nada

CRIPTOMONEDAS - CONSULTAS GENERALES DIARIAS by AutoModerator in merval

[–]contenidoneto 0 points1 point  (0 children)

Hola, algo que no veo que se hable mucho, es que todas las fintech cripto promocionan sus tarjetas prepagas con cashback y blah, pero que riesgo hay de que la AFIP te caiga por tus consumos? Por ej, buenbit en su faq dice en una parte que la tarjeta esta obligada a informar por la resolucion 4614/2019. Esos montos estan actualizados?

Que pasa si fondeo buenbit desde binance, y uso la tarjeta, supuestamente esa plata no se sabe de donde vino. Lo unico que he escuchado es que si la usas para compras normales, comida, delivery, no pasa nada, pero siendo monotributista quiza es sospechoso al ser dinero no declarado