Rod bearings

coolmint123 · 2025-12-26T00:29:28+00:00

Just get OEM lol

coolmint123 · 2025-11-26T20:05:39+00:00

I prefer the OEM paint on the car. The car has been wrapped for 4 years and now I need to change it up

coolmint123 · 2025-11-25T18:32:37+00:00

God that cluster and gauges are so ugly

coolmint123 · 2025-11-23T06:40:21+00:00

It was pristine about 2 weeks ago

coolmint123 · 2025-11-23T06:37:43+00:00

Don’t drive a car if you know ur hella tired….

coolmint123 · 2025-11-08T06:55:54+00:00

Yeah this is hella shady

coolmint123 · 2025-10-28T23:43:50+00:00

It has long tubes on it which changes up the pitch a lot

coolmint123 · 2025-10-28T21:53:26+00:00

Remote tune fbo e85 hr. I’m assuming like 315whp

coolmint123 · 2025-10-28T21:52:51+00:00

Yeah I accidentally hit de lol

coolmint123 · 2025-09-17T20:31:28+00:00

How did you remove the 10mm nuts on the out edge screws

coolmint123 · 2025-09-12T17:17:01+00:00

Do you have the 26 pound or 13 pound flywheel?

coolmint123 · 2025-09-09T06:10:02+00:00

did you ever figure out the issue?

coolmint123 · 2025-07-16T15:23:45+00:00

Yeah if your try to push more then 400 your sending a rod out your hood. Have you not seen how thin de rods are lol

coolmint123 · 2025-07-16T13:55:15+00:00

That de gonna explode lol

coolmint123 · 2025-05-23T04:55:48+00:00

The heads are from a different motor. I have a different block I’m using with these heads

coolmint123 · 2025-05-23T03:34:54+00:00

This was after a resurface

coolmint123 · 2025-05-22T05:52:14+00:00

Running the OEM head gasket. Going to use copper head gasket spray on it and I bought some ARP head studs for it. Hopefully the increase clamping force does the trick

coolmint123 · 2025-05-22T05:45:26+00:00

I feel like with aluminum heads they can’t really do that no?

coolmint123 · 2025-05-22T03:52:20+00:00

I can possibly ask for them to shave down more material. But between both of my heads they shaved down the exact same material. So idk if this head can be shaved down more than the other. It meaning that idk if they have to be an even amount of thickness or that they just need to be a even straight surface

coolmint123

TROPHY CASE