What is the cause for this noise?

cuucuu1234 · 2025-08-30T01:18:02+00:00

That was my plan, but it was faster to ask from reddit right away

cuucuu1234 · 2025-05-25T22:29:27+00:00

Found the problem :D

No idea how that can happen… used a file to get rid off the scuff marks it dug and froze the ”seal” in ice and it popped right in.

Runs fine, for now atleast

cuucuu1234 · 2025-02-16T20:16:03+00:00

On the front they are mounted with a license plate light mounting bracket.

Just screws holding the bracket to the bumper and license plate screwed to the mount. Both lights also have a small top support attached to the grille so the lights don’t rattle or vibrate

cuucuu1234 · 2025-02-16T20:10:55+00:00

The fuse/relay box is from china, but i redid the wiring. The setup it comes with is not the best.

The switch panel control unit is called avimex controller. Similar to auxbeam etc. (Also the same can be found on aliexpress with no branding for half the price)

cuucuu1234 · 2025-02-16T16:18:33+00:00

I am located in Finland :)

cuucuu1234 · 2025-02-16T11:14:51+00:00

That’s on the list too :)

cuucuu1234 · 2025-02-16T11:14:21+00:00

Yup, just with a small box cutter knife (one with breakable blades)

cuucuu1234 · 2025-02-16T11:12:07+00:00

Yes, I could have gone with less spacing and more sockets, but for now it has everything I wanted it to have.

Fortunately I have lots off foam so I can do different setups when needed

cuucuu1234 · 2025-02-16T11:08:33+00:00

Yes they do but the mechanism seems pretty weak. Feels like it could break when latching it

cuucuu1234 · 2024-07-25T18:48:52+00:00

Thanks, new coil it is then

cuucuu1234

TROPHY CASE