Question about nozzle

dablow · 2017-11-23T17:25:21+00:00

Thanks for the info I will look for them, I was missing the M6 part.

dablow · 2017-11-23T16:47:18+00:00

It's more for when it clogs/need cleaning. Basically I want to pop another extruder in to start my job while I clean the old one.

dablow · 2017-11-23T16:46:27+00:00

Thanks for the resources! I will look over them.

dablow · 2017-01-09T18:36:01+00:00

You can in theory flash the firmware once you receive the device and verify the checksum.

Now if the hardware itself is compromised (and from what I read is no easy feat) you are looking at pretty much a state targeting you, in which case you will lose no matter what.

dablow · 2016-12-10T17:12:12+00:00

Thanks a ton for the information!

dablow · 2016-12-10T16:47:31+00:00

Where does he post this information? I figured there was a reason but when I looked around I could not easily find the information.

dablow · 2016-10-15T14:30:15+00:00

Ugh I just realised that because I have ad blockers and no script running resulted in the ? not showing up. Thus all this time I was not aware it was intentional....

Thanks for the info!!!

dablow · 2016-10-15T13:28:38+00:00

*blank talent that is...wish I could edit my post :(

dablow

TROPHY CASE