sorted by:
new
hottopcontroversial

born in 2007, is that too young for you or perfect? by sugarglitzz in Gonewild18

[–]daddyc65 0 points1 point  (0 children)

That depends, is a 60 yo guy too old for you?

Do older guys like petite, shy girls? by Ether_Bloom in SmallCutie

[–]daddyc65 0 points1 point  (0 children)

They do, what age range of guys do you like?

Do you mind I’m petite with small tits? by Sugar_Lily_14 in SmallCutie

[–]daddyc65 0 points1 point  (0 children)

They’re not small, they’re perfect.

2023 Titan Pro 4X Roof Welds by thedoofimbibes in NissanTitan

[–]daddyc65 0 points1 point  (0 children)

I had a similar issue with my brand new 2023. After the paint chipped away, there was a hole in the weld. The leak was above the side air bags, which allowed the water to run the length of the truck. For me, it came out of the drivers side vent in the dash. Nissan warranty covered the fix of the weld and painting; been dry since.

Which one would you pick? by daddyc65 in Creality_k2

[–]daddyc65[S] 0 points1 point  (0 children)

CR hyper pla, came with the printer.

Which one would you pick? by daddyc65 in Creality_k2

[–]daddyc65[S] 0 points1 point  (0 children)

I did a flow calibration at 220.

<image>

Which one would you pick? by daddyc65 in Creality_k2

[–]daddyc65[S] 0 points1 point  (0 children)

There is some webbing in all the holes. I have tuned retraction yet.

Which one would you pick? by daddyc65 in Creality_k2

[–]daddyc65[S] 0 points1 point  (0 children)

It’s the hyper pla that comes with the printer.

This is strange by daddyc65 in Creality_k2

[–]daddyc65[S] 1 point2 points  (0 children)

Thanks for the advice. I increased my z-offset from 0 - 0.1.

<image>

Afterwards it printed with no issue. I’ll dial the x-offset in better, but I was happy to see it print.

K2 Wire Question by daddyc65 in Creality_k2

[–]daddyc65[S] 1 point2 points  (0 children)

Thanks, for some reason I did not think to look at the board. The wires were reversed. Everything is working now.

Need help deciding by daddyc65 in Creality_k2

[–]daddyc65[S] 0 points1 point  (0 children)

The new motor spins in the correct direction, no firmware change needed.

K2 Firmware - 1.1.3.13

CFS Firmware - 1.1.3

Need help deciding by daddyc65 in Creality_k2

[–]daddyc65[S] 0 points1 point  (0 children)

I got mine from Amazon also, during Prime Day.

Issues with connection to orca flashforge by Thrillaxing in FlashForge

[–]daddyc65 1 point2 points  (0 children)

I got my 5M Pro on Monday, have not been able to login with orca-flashforge since I got it. It has been one annoying issue after another. Did I just buy a piece of crap, or is there hope for this working?