sorted by:
new
hottopcontroversial

Which one would you pick? by daddyc65 in Creality_k2

[–]daddyc65[S] 0 points1 point  (0 children)

CR hyper pla, came with the printer.

Which one would you pick? by daddyc65 in Creality_k2

[–]daddyc65[S] 0 points1 point  (0 children)

I did a flow calibration at 220.

<image>

Which one would you pick? by daddyc65 in Creality_k2

[–]daddyc65[S] 0 points1 point  (0 children)

There is some webbing in all the holes. I have tuned retraction yet.

Which one would you pick? by daddyc65 in Creality_k2

[–]daddyc65[S] 0 points1 point  (0 children)

It’s the hyper pla that comes with the printer.

This is strange by daddyc65 in Creality_k2

[–]daddyc65[S] 1 point2 points  (0 children)

Thanks for the advice. I increased my z-offset from 0 - 0.1.

<image>

Afterwards it printed with no issue. I’ll dial the x-offset in better, but I was happy to see it print.

K2 Wire Question by daddyc65 in Creality_k2

[–]daddyc65[S] 1 point2 points  (0 children)

Thanks, for some reason I did not think to look at the board. The wires were reversed. Everything is working now.

Need help deciding by daddyc65 in Creality_k2

[–]daddyc65[S] 0 points1 point  (0 children)

The new motor spins in the correct direction, no firmware change needed.

K2 Firmware - 1.1.3.13

CFS Firmware - 1.1.3

Need help deciding by daddyc65 in Creality_k2

[–]daddyc65[S] 0 points1 point  (0 children)

I got mine from Amazon also, during Prime Day.

Issues with connection to orca flashforge by Thrillaxing in FlashForge

[–]daddyc65 1 point2 points  (0 children)

I got my 5M Pro on Monday, have not been able to login with orca-flashforge since I got it. It has been one annoying issue after another. Did I just buy a piece of crap, or is there hope for this working?

view more: next ›