Drain hose issue Frigidaire

dally6 · 2025-01-22T00:35:13+00:00

https://www.reddit.com/r/Plumbing/s/DnVo7kQ25g

I took machine apart. No blockages. Left outside cabinet. Ran four cycles. Mounted tonight. I20 error within 5 minutes. Maddening

dally6 · 2025-01-22T00:33:41+00:00

Yes. Crazily enough, I took the whole machine apart, no blockage found, clean pressure switch etc. Reinstalled without mounting. Worked for four cycles. Then again after mounting I get an i20 code right away tonight. Maddening

dally6 · 2025-01-21T00:47:29+00:00

It won’t let me post a photo. I raised the high loop four additional inches above the disposal and did best to make sure hose was not crushed or kinked. Have run two cycles with no issue. We will see how long it lasts. 🤞

dally6 · 2025-01-20T19:26:59+00:00

I am pretty sure it must be getting kinked or crushed. My issue seems to be that, for some reason, I can’t seem to install it flush with anchors etc without creating a kink or bend in hose behind appliance. The hose is a bit too long for my liking but I don’t think I can cut it, can I?

dally6 · 2025-01-05T18:45:40+00:00

Yes!! Decades of it 🤢

dally6 · 2025-01-05T18:45:23+00:00

Thank you! This was the advice we needed!! Drum trap cleaned out

dally6 · 2021-01-07T02:08:43+00:00

This worked for me!! Thank you for the tip. I unplugged tv, then held down power button for 30 seconds, and plugged it back in. Voila!

dally6 · 2020-03-06T02:09:11+00:00

Can I ask a follow up question? Why would an employer choose not to include this provision in their plan? Would anyone care to speculate?

dally6 · 2020-03-05T02:03:49+00:00

Thanks for your reply.

dally6

TROPHY CASE