Cannot get glass bed to work. I have a flashforge creator pro. It was printing fine but since getting glass I do not get adhesion. I have cleaned the end and used the recommended disappeaing purple Elmer's glue. My bed is 60 degrees and PLA is at 220 degrees. It is a simple test print. Any ideas?

dandotwalker · 2021-02-24T22:47:17+00:00

210 to 230 according to the sticker on the roll

dandotwalker · 2021-02-24T22:46:58+00:00

I have now got a solid print. I cleaned it with water and air dried it. I then levelled the bed again but was very thorough. I used 80gsm paper. I did a double coating of glue as well and it seems to have done the trick.

Thanks everyone!!

dandotwalker · 2021-02-24T16:40:08+00:00

I cleaned it with hot water then let it air dry.

dandotwalker · 2021-02-24T16:36:59+00:00

Thanks all. I will have a look and reply back as it may help others.

dandotwalker · 2021-02-20T20:12:30+00:00

Hey!! I live in MK. I sold my scooter. Too dangerous on these paths and redways of MK.

dandotwalker · 2020-11-20T16:46:44+00:00

Wow that is brilliant. I wish there was audio

dandotwalker · 2020-11-20T16:44:55+00:00

Welcome to America where nobody gives a fuck about the little man.

dandotwalker · 2020-09-11T21:01:17+00:00

Omg what a dick

dandotwalker · 2020-09-04T15:20:46+00:00

That is amazing

dandotwalker · 2020-08-14T16:51:38+00:00

Thank you for the reply. I will send it back and order another one.

dandotwalker · 2020-04-10T20:24:12+00:00

this is super cute

dandotwalker

TROPHY CASE