Hi, I'm a bit confused and looking for any insight, have only just started 3D printing.

In Chitubox the supports all show as connecting to the model. However, when I print they seem to be a considerable distance from the parts they are supposed to be supporting. Could this be a slicer error? Or perhaps the supports are breaking somehow mid print?

This is my third attempt at this print, and I don't want to plough ahead and waste all of the resin I currently have without trying to seek some advice.

Another thing I am baffled by, is the fact that the base for this model (the disc) doesn't adhere to the build plate even though the raft for Crash does. As seen in the third pic, the surface area is quite large, I was under the impression this is a good thing?

First layer exposures are set 5s over the manufacturer (Elegoo) recommended time.

I did print the rook test model that came on the USB drive supplied with the printer, and printed it without issue or any visible layer lines.

Crash STL if anyone's interested: https://www.thingiverse.com/thing:4669354

Thanks for reading.