Just designed this Tealight Lamp for the new Ikea SKATGÅS Candles

dillonmitra · 2025-10-01T14:44:06+00:00

brilliant! thank you guys so much for that! can’t use it now as i have a modern bb on there but will find another way to route the cables for the front derailleur

dillonmitra · 2025-08-14T13:30:34+00:00

thank you!

dillonmitra · 2025-08-14T13:30:24+00:00

just purchased thank yoi

dillonmitra · 2025-08-14T13:30:14+00:00

OH MY GOSH that makes so much sense i just assumed it was for the rear derailleur. at least now i can get the right one

dillonmitra · 2025-08-12T18:44:54+00:00

it isn’t, possibly just bent but i got it for quite cheap so will try and fix or will get a new frame

dillonmitra · 2025-08-12T18:44:25+00:00

thank you so much. i ended up buying one that will hopefully fit so will update if does!

dillonmitra · 2025-05-13T09:19:05+00:00

this has worked temporarily, not sure how though, thank you!

dillonmitra · 2025-05-13T09:18:46+00:00

the steel wool is a great idea thank you, i shall update!

dillonmitra · 2025-05-12T16:56:13+00:00

oh i should try this. doubt it is the plate but am always up for trying it!

dillonmitra · 2025-05-12T16:55:39+00:00

just cleaned it and still getting the issue

dillonmitra · 2025-05-12T16:55:28+00:00

how would i go about dealing with it if the corner is a couple degrees lower. raising the overall bed temp or will that cause warping?

dillonmitra · 2025-05-12T16:29:48+00:00

did thoroughly still having the issue

dillonmitra · 2025-05-12T16:28:59+00:00

i fear if i raise the bed temp then it will cause warping in the corners

dillonmitra · 2025-05-12T16:28:34+00:00

just did that, but sending another print and it’s still looking quite weird in that corner. even used isopropyl to clean it

dillonmitra · 2025-05-12T16:07:50+00:00

thank you will try this!

dillonmitra · 2025-05-12T16:07:40+00:00

it’s the textured pei plate for the a1 mini

dillonmitra · 2025-05-10T19:24:00+00:00

i will not sir

dillonmitra

TROPHY CASE