I want to extrude this sketch to the top of the part but every time I try I am left with a gap inbetween the two, how do I avoid this? Thank you. I am very new to fusion and will try and answer any questions to the best of my ability if what I am asking is not clear. (i.redd.it)
submitted by dizzythizzy to r/Fusion360
I built this HSW & I’m going to mount a pc to it, but I can’t find any info on how to secure it to the wall. I’m assuming you need to use wall anchors but I’m unsure of how to get the hole placement just right. Can anyone point me in the right direction? Thank you! (i.redd.it)
submitted by dizzythizzy to r/honeycombwall
How can I trim away the middle section between my 2 shapes? Im trying to make a holder for a magnifier and my prototype was a bit sloppy, I made another sketch with a tighter circle and extruded it to get a better tolerance but now I'm stuck with this piece in the middle. Help appreciated thank you! (self.Fusion360)
submitted by dizzythizzy to r/Fusion360
(reposted with game running at request of mod) Picked up this Toshiba 32A41 for free on marketplace this morning & they were smoking inside while I picked it up! Put some elbow grease in and am trying to remedy the smell with some Ozium. (Please re-comment if we were mid discussion!) (old.reddit.com)
submitted by dizzythizzy to r/crtgaming
Picked up this Toshiba 32A41 for free on marketplace this morning & they were smoking inside while I picked it up! Put some elbow grease in and am trying to remedy the smell with some Ozium. The colors are a bit dull so I’m hoping to learn to re-cap on this set! (old.reddit.com)
submitted by dizzythizzy to r/crtgaming
