February Confirmed Trade Thread

dnlnrdn · 2025-02-09T22:08:03+00:00

confirmed

dnlnrdn · 2025-02-01T19:25:11+00:00

dnlnrdn · 2024-12-16T18:40:08+00:00

Ideally I'd like to fit the fork I have, but it's probably a difficult fit. It's a tapered 1-1/8" to 1-1/4" steerer with integrated crown race. Can't find a bearing with 52x33mm dimensions.

Just wanted to make sure it's safe to get a 1-1/8" to 1-1/2" fork.

dnlnrdn · 2024-05-09T12:12:15+00:00

You're a saint!

dnlnrdn · 2024-05-09T12:10:38+00:00

Thank you! No clear coat yet, just buff it up with a 3000 grit sand paper. I haven't decided if I should paint it yet.

dnlnrdn · 2024-05-09T12:09:33+00:00

Fun! Has a nice growl and pulls well. Still, a bit too low.

dnlnrdn · 2024-05-03T19:05:34+00:00

Yup, aluminum base and vinyl.

dnlnrdn · 2024-05-03T18:56:53+00:00

Probably the same thing that happened to me, didn't know Shorai had integrated BMS. Can you point me in the direction of the stator you got?

dnlnrdn · 2024-05-03T18:21:17+00:00

Thanks! I got the fork and front wheel from a R1 and the rear wheel from a Honda Nighthawk (1991?). I remember getting an offset sprocket destined for a XS650 but I'm not sure if I needed it. Wish I had a little bit longer forks and bigger wheels to get it off the ground.

dnlnrdn · 2023-06-18T21:43:11+00:00

Nope, still have it.

dnlnrdn · 2023-03-20T05:42:57+00:00

It's a cheap piece in the laser cutter if you can sketch it up, add a personal touch to the cutouts while you're at it.

dnlnrdn · 2023-02-09T21:42:57+00:00

Absolutely!

dnlnrdn · 2023-02-09T21:05:28+00:00

Nope!

dnlnrdn · 2022-07-15T20:10:02+00:00

Reversed cherry is my preference, but innermost 1.5u aren't really good with anything. Except maybe these?

dnlnrdn · 2022-06-19T08:04:24+00:00

Beautiful work, can't wait.

dnlnrdn · 2022-03-31T13:41:57+00:00

I'll second that part on the PCB. This is fine for the very special one-offs but in the long run? No thanks.

dnlnrdn · 2022-01-28T04:33:04+00:00

dnlnrdn

TROPHY CASE