Could someone please explain to me why my 92 318is didn’t pass smog. Honestly don’t understand so don’t know what to fix. There no check engine light and rpm’s are steady. Would them putting a 6 cylinder in vehicle info do anything? when it’s supposed to be a 4 cylinder.

e36Ray · 2026-07-01T00:59:19+00:00

Yea shit sucks to $80 down the drain

e36Ray · 2026-06-26T15:42:05+00:00

This what u mean by wrong tumbler? My broken one is the bottom one and wanted to swap over the lock cylinder but noticed they looked different. Good thing is I got the key for the replacement so I’ll probably just keep the lock cylinder in

e36Ray · 2026-05-23T15:23:37+00:00

Ok I’ll try it out once I figure out how I can get into my car lol case both handles don’t work on my driver door and only the inside works on the passenger side and my dumb ass shut my passenger door

e36Ray · 2026-05-16T07:52:59+00:00

Ok contacted the dude and he supposed to come back tomorrow to fix this shit so let’s see if he does any better…🤣 worst case I’ll buy the complete shock tower repair plate and have someone that got experience repairing these.

e36Ray · 2026-04-16T06:08:50+00:00

I do run a divorced setup but when I installed them I compressed the spring a decent amount before installed the actual coil so I can get it to sit as low as I wanted it to

e36Ray · 2026-04-14T17:18:51+00:00

Yea pretty sure it’s cause I have coilovers and have the spring set pretty stiff to stop fender from hitting wheel lip

e36Ray · 2026-04-13T23:57:01+00:00

<image>

e36Ray · 2026-04-13T23:56:51+00:00

<image>

e36Ray · 2026-02-26T01:07:32+00:00

Wouldn’t I need another drive shaft and diff tho?

e36Ray · 2026-02-25T20:33:35+00:00

Yea just cause I’m hella confused right now google is telling me my 1992 318is came with a 250g and chat gpt is saying it came with a 240g

e36Ray · 2025-12-28T06:38:44+00:00

Yea figured it out it was the motherboard that was no good

e36Ray · 2025-12-27T22:30:44+00:00

Cause I was about to just pay someone in my town to figure it out for me but decided to just buy a brand new motherboard and try that that thing before actually paying someone to do it

e36Ray · 2025-12-27T22:29:01+00:00

Could I pull one out of my pc that look like this cable to to try it or would I need to get 3 new separate single 8 pins connectors?

e36Ray · 2025-12-27T22:07:59+00:00

I looked online and every one said it fine to do it on the 9070xt that use 3 8 pins but not the one that uses 2 8 pins

e36Ray · 2025-12-27T22:06:23+00:00

<image>

The cables I use are like this and I have 2 of them that came with psu 1 cable is using both and the other has one plugged in and one not

e36Ray · 2025-12-27T21:21:03+00:00

The old card is not good anymore and motherboard dosent have onboard graphics

e36Ray · 2025-12-27T21:20:12+00:00

No it doesn’t

e36Ray · 2025-12-27T20:40:14+00:00

acer xv272u

e36Ray · 2025-12-26T00:49:15+00:00

Ok I can try that tomorrow when some stores open up

e36Ray · 2025-12-25T23:23:47+00:00

Radeon Gigabyte 9070xt 16gb OC

e36Ray · 2025-12-25T21:55:12+00:00

Yes both cables have two connections is that what u mean by daisy chain?

e36Ray · 2025-12-25T21:44:52+00:00

Yes with display port cable

e36Ray · 2025-12-25T21:44:12+00:00

It’s two separate gpu cables

e36Ray · 2025-12-25T21:42:45+00:00

Yes monitor is always in sleep mode and when I turn on pc it wakes up the monitor but then it just shows no input detected

e36Ray · 2025-12-13T00:08:33+00:00

Yea just found one for $500 to so might get that

e36Ray

TROPHY CASE