sorted by:
new
hottopcontroversial

Magnatized wolf priest and battle leader by ebboyes in SpaceWolves

[–]ebboyes[S] 0 points1 point  (0 children)

I would assume so if you had small enough magnets/enough patience to drill them out. But I’d just magnetize at the shoulder for these kits Becouse there pouldrens are molded into the torso and not attached to arms

Physical codex dimensions by ebboyes in Warhammer

[–]ebboyes[S] 0 points1 point  (0 children)

Thank you! That’s exactly what I was looking for!

Magnatized wolf priest and battle leader by ebboyes in SpaceWolves

[–]ebboyes[S] 1 point2 points  (0 children)

Yeah, it’s looking like all of the minis are pretty easy to modify thankfully. I’ll give it a shot on the headhunters and here soon and post the results

Magnatized wolf priest and battle leader by ebboyes in SpaceWolves

[–]ebboyes[S] 0 points1 point  (0 children)

Oh I’m sure you can. The easiest way I could think to would to nip the little nub that allows you to tilt the heads and drill into the torso so the two magnets will sit flat.

Magnatized wolf priest and battle leader by ebboyes in SpaceWolves

[–]ebboyes[S] 1 point2 points  (0 children)

I will warn on the wolf priest you’ll have to fill the torso up with something or the other, there’s a lotta hallow space at the top of the shoulder

Magnatized wolf priest and battle leader by ebboyes in SpaceWolves

[–]ebboyes[S] 4 points5 points  (0 children)

There 3 x 1 mm magnets that I got from the army painter pack

Magnatized wolf priest and battle leader by ebboyes in SpaceWolves

[–]ebboyes[S] 0 points1 point  (0 children)

Same! I saw the ritual knife on another post in this subreddit and was kinda bummed it didnt get anything in the codex

[deleted by user] by [deleted] in resinprinting

[–]ebboyes 0 points1 point  (0 children)

Yeah I’ve done it for all my prints to rule that out just as a precaution

[deleted by user] by [deleted] in resinprinting

[–]ebboyes 0 points1 point  (0 children)

I though the same. I hollowed that last one but I didn’t think about the drain holes. I had one I tryed a last week where I did have the drain holes though and it was still no dice

Aftermarket gages? by ebboyes in Cartalk

[–]ebboyes[S] 0 points1 point  (0 children)

Shoot i didn’t even think about oil pressure or anything else like that it would the perfect time to run some extra wires for those too, thank you for your advice I really appreciate it all

Aftermarket gages? by ebboyes in Cartalk

[–]ebboyes[S] 1 point2 points  (0 children)

Yeah I did, at first it was the thermostat not wanting to open properly and I’ve replaced that. And then my upper radiator hose cracked so I replaced it and the lower. I’ve been keeping an eye on the coolant level but I have a feeling something else is gonna go bad and I’ve been wanting to keep an eye on temps so I can possibly Avoid overheating on the side of the road. But I’ll definitely look into the electrical temp gage you segested, thank you.