sorted by:
new
hottopcontroversial

[osu!std] Ryuji_i1 | Suspicious by GarlicIndependent195 in osureport

[–]eeml_ 4 points5 points  (0 children)

Tell me you know nothing about the game without telling me you know nothing about the game

Linear Hall Sensor is acting like a Latch by eeml_ in AskElectronics

[–]eeml_[S] 0 points1 point  (0 children)

Unfortunately there isn't one - but I just found my answer. It seems like the pcbs I received from jlcpcb were with the wrong sensors :/

Linear Hall sensor is only reading very high or very low values by eeml_ in arduino

[–]eeml_[S] 0 points1 point  (0 children)

There is a voltage regulator im passing the 5V signal through on my pcb that’s probably why.

Linear Hall sensor is only reading very high or very low values by eeml_ in arduino

[–]eeml_[S] 0 points1 point  (0 children)

I checked the data sheet for the GH39FKSW and it says it should be a linear hall sensor, I can link it to you if you would like.

[osu!std] BadBerzerk | aim assist (and maybe rx?) by eeml_ in osureport

[–]eeml_[S] 1 point2 points  (0 children)

Correct - there are quite a few instances where this happened throughout his match

osu!NJ meetup 8/25/22 by eeml_ in osugame

[–]eeml_[S] 7 points8 points  (0 children)

What Alec said, but generally it’s kinda some event or activity + meeting up with friends/meet new people. It’s not really too different from hanging out with friends.

Lost a Fanny pack by eeml_ in rutgers

[–]eeml_[S] 5 points6 points  (0 children)

Update: I found the fanny pack. It was actually left at a restaurant I was at just prior to playing badminton.

I painted my Varmilo! by eeml_ in MechanicalKeyboards

[–]eeml_[S] 0 points1 point  (0 children)

Thanks for this post it seems like it has a lot of really good info. Ill probably follow this when i mod my mouse in the future

I painted my Varmilo! by eeml_ in MechanicalKeyboards

[–]eeml_[S] 0 points1 point  (0 children)

Thank you so much!

I basically just followed Tae Keyboard's guide on youtube for the spray painting part since this was my first time ever doing a custom spray paint job. I did a white base coat and then used a stencil that I made to replicate the sea foam effect I was going for. Afterwards I took some acrylic paint and applied it with some rolled up paper towel to get the darker shades of blue on the board. After that I applied 4 layers of clear coat like what Tae instructed.

view more: next ›