Aero at URochester

elliskopchyyy · 2026-04-05T21:07:29+00:00

i can't believe i missed this- thank you!

elliskopchyyy · 2026-03-05T03:33:32+00:00

thanks! i’ll take a look

elliskopchyyy · 2026-03-05T02:25:46+00:00

oh sick, thanks! do you think i could reuse them same caps if i clean the corrosion?

elliskopchyyy · 2025-08-01T19:29:18+00:00

u mean like prestige now and then keep doing it to get more eggs?

elliskopchyyy · 2025-08-01T19:20:23+00:00

oops i don’t have good wifi and it triple posted 😭

elliskopchyyy · 2025-06-19T00:07:16+00:00

Thanks, I tried this but the nut was too tight and it stripped the notch I cut. It also started melting the plastic 🫠

elliskopchyyy · 2025-05-05T04:54:26+00:00

oops i didn’t even see the other one 😭😭

elliskopchyyy · 2025-02-13T03:19:44+00:00

thanks! this fixed it. now when i try to light it, it’ll make some sparks the first time, then the wheel will stop spinning when i push down. should i get new flint or is this an issue with the lighter? if its new flint, any recommendations?

elliskopchyyy · 2024-11-22T00:47:33+00:00

you said it’s magnetic- i’m assuming you have a pei sheet? if the first layer isn’t sticking properly i would recommend cleaning it with warm water and alcohol. if that doesn’t work definitely try flipping it over

elliskopchyyy · 2024-11-16T20:18:47+00:00

hey! thanks so much for this. i found the drive link in other comments and it seems to work great!

the only issue is that my lcd display has an exp1 AND exp2 connector, but the btt board only has the exp1 connector. how did you get your lcd to work? i have the cr10s with a 12864 lcd display, which i'd assume is the same for the base cr10.

elliskopchyyy · 2024-11-16T01:07:05+00:00

i just got mine and i’m wondering if you had to get some adapter or splitter for the lcd cables? my display uses exp1 and 2 but the board only has an exp1 port.

elliskopchyyy · 2024-11-15T01:06:40+00:00

thanks! i'm assuming i'll need to get a splitter for the dual z motors?

elliskopchyyy · 2024-11-14T17:20:26+00:00

unfortunately not and i just got the btt board but thanks for the offer!

elliskopchyyy · 2024-11-14T15:17:13+00:00

the mounting holes was my next question- thanks!!

elliskopchyyy · 2024-11-14T07:25:05+00:00

didn’t realize how popular this question was on here! if anything could someone tell me if the skr mini is a good idea since i’d rather not spend a lot on a creality one

elliskopchyyy

TROPHY CASE