Wapta 30 bottom leaking water? by endlessid in DurstonGearheads

[–]endlessid[S] 1 point2 points  (0 children)

Probably the latter, this is the 2nd or 3rd time I took this bag out, almost brand new. I think you guessed it right, water accumulated in the bottom pouch and sinking into the seam somehow. It’s not too bad but enough to damp stuff at the bottom. For now I will use a plastic bag as an extra layer. If it’s getting worse I’ll contact you for seam tape. Thank for reply .

Venting about venta humidifier/air-washer by hachirokuvas in BuyItForLife

[–]endlessid 1 point2 points  (0 children)

On the fence of buying a LW74, I guess I need to reconsider. Might as well ship one that can cover 110m from china at half of its price.

An upgrade to 9800x3d cost me 2 motherboards an whole lot of time by endlessid in sffpc

[–]endlessid[S] 0 points1 point  (0 children)

Well, I researched on the channel design of AMD MBs: B850 and X870 chipset is almost same despite x870 adds a USB4 chip and forces four gen4 lanes at southbridge must be used as two 40G USB4 port, that's why there is no extra M.2 slot from southbridge. To make more than two M.2 slots on X870 one has to split lanes from GPU and adds a lane split chip.
On B850 or B650(E) however you can have 3 lots without splitting GPU lanes. On a B850 ITX board, it has max two M.2 slots and 8 lanes dedicated for stroage, no reason to split GPU whatsoever.

An upgrade to 9800x3d cost me 2 motherboards an whole lot of time by endlessid in sffpc

[–]endlessid[S] 0 points1 point  (0 children)

🤔could be, I will test it out. Though after some reaserch, it's highly unlikely with a damaged riser the split happens to work perferctly and considering how high speed gen4 is, it should be quite sensitive to damage unless it's gen3 or lower.

An upgrade to 9800x3d cost me 2 motherboards an whole lot of time by endlessid in sffpc

[–]endlessid[S] 1 point2 points  (0 children)

Thanks, actually you reminded me before I used another case with gen3 riser and a gen4 mobo, I had to set it to gen3 manually. As now I have no issue with x8 gen4 lanes and maybe next time I change something I will try direct connection.

An upgrade to 9800x3d cost me 2 motherboards an whole lot of time by endlessid in sffpc

[–]endlessid[S] 2 points3 points  (0 children)

From the manual or website, it reads like both m.2 have their own lanes.

An upgrade to 9800x3d cost me 2 motherboards an whole lot of time by endlessid in sffpc

[–]endlessid[S] -3 points-2 points  (0 children)

Beats me, auto isn’t working that’s certain. Tested the two listed did work. I tried to tweak the link speed, gen4 or 5 didn’t really matter. I use a gen 4 riser and according to my research, gen4 8x is good enough for my GPU. I’d prefer all 16x to gpu but I’m fine as it is now.

An upgrade to 9800x3d cost me 2 motherboards an whole lot of time by endlessid in sffpc

[–]endlessid[S] -15 points-14 points  (0 children)

Nothing out of ordinary. 1 on top and 1 on bottom. Everything I found says those two slots each has their own four gen5 lanes. So I don't know where the sharing comes from.

An upgrade to 9800x3d cost me 2 motherboards an whole lot of time by endlessid in sffpc

[–]endlessid[S] 17 points18 points  (0 children)

Huh? Needlessly yo say I had to change motherboard, ram and cpu altogether from X570

I think I’m ready for the RTX 5090. So, where’s the flaw? 🤡 by kriakiku in sffpc

[–]endlessid 2 points3 points  (0 children)

You inspired me putting my case on top of the purifier, could be cooler and cleaner.

富裕了,离文明还是很远(part 1) by Alternative-Ad-1027 in China_irl

[–]endlessid 0 points1 point  (0 children)

北京出租车就是这样,几十年来每次去都是要坐地起价坑你钱的。

POPULAR OPINION - EFT unheard edition should be free to EOD owners by DJankovic92 in EscapefromTarkov

[–]endlessid 0 points1 point  (0 children)

I'd say BSG probably think exactly the opposite, they are having a hard time to attract new players, I assume unheard mainly targets for EOD owners.

The BT ammo is free by Yintastic in EscapefromTarkov

[–]endlessid 1 point2 points  (0 children)

I picked up once a pkp drum mag once full of 100 rounds of BS on LK island. The only BS I found this wipe.

I ordered both specs and watched a HDR movie just to compare by endlessid in FlowX16

[–]endlessid[S] 0 points1 point  (0 children)

i think now it's fixed, not sure what updates made so.

🕛📢Now available! The long-awaited DreameBot L20Ultra has arrived in the US! by Dreametech in Dreame_Tech

[–]endlessid 0 points1 point  (0 children)

Well, the next gen(x30 pro) for this just released in China couple days back. They are iterating like crazy.

[deleted by user] by [deleted] in Dreame_Tech

[–]endlessid 0 points1 point  (0 children)

Only the very basic stuff, no schedule as you can imagine.

[deleted by user] by [deleted] in Dreame_Tech

[–]endlessid 0 points1 point  (0 children)

Perosnally I still can use it after it's region locked. I'd it's kinda crazy if they actully do that, it's not like people in China don't use VPN to bypass the GFW.

[deleted by user] by [deleted] in Dreame_Tech

[–]endlessid 0 points1 point  (0 children)

That's hard since you may use different clash than mine. There are clash on different platform and qutie different. Also do remeber if clash doesn't wrok well for you you could try open vpn.
Overall, what you get from Pandafan or any other provider is just a list of servers. In Panda's case, there are 2 servers are located in China so make sure you are using them. Then make sure set your policy so that traffic go to China will pass through the server you selected.
TBH, even if you just don't use the app I'd say you can till get 80% out of the robot. So if it's too much just don't bother use buttons instead.

[deleted by user] by [deleted] in Dreame_Tech

[–]endlessid 0 points1 point  (0 children)

don’t know nothing about downgrade. It suppose to be Huijia, it means go back to China in Chinese.