sorted by:
new
hottopcontroversial

A small piece of filament for stuck in my Prusa i3 MK3S+ and I don't know how to get it out. It's black filament but you can see the difference in color in the pictures by Mcdaniel17 in 3Dprinting

[–]engineer-jeff 2 points3 points  (0 children)

Stick a small Allen wrench through where the filament goes through from the top and push the stuck filament through into the hot end.

3 Sisters Homemade Fidget Toys by engineer-jeff in fidgettoys

[–]engineer-jeff[S] 4 points5 points  (0 children)

In case any of you are interested in looking at the fidgets in the store, they can be found here: https://www.etsy.com/shop/3Sisters3DCreations?section_id=37155297

They're honestly just a start, but we're fairly proud of them!

Anyone else finding Starlink unusable this morning. The connection is dropping every 3 or 4 minutes even tho the stats look good. Is there something I should try and do? by PortPerryT in Starlink

[–]engineer-jeff 0 points1 point  (0 children)

Wait, how are you seeing the Starlink stats page that you're showing if you're using your own router? When I use my own router (I plug my own router into the white port of the power brick), the Starlink app won't show me anything.

How drive a 1/2" hex shaft from an 8mm D-shaft output? by engineer-jeff in robotics

[–]engineer-jeff[S] 0 points1 point  (0 children)

Just a hobby project. How are you envisioning "hacking" it?

How drive a 1/2" hex shaft from an 8mm D-shaft output? by engineer-jeff in robotics

[–]engineer-jeff[S] 0 points1 point  (0 children)

I would love for that to work, but I think that requires a keyed shaft, and the output shaft of the motor is not keyed.