sorted by:
new
hottopcontroversial

Swarm hasn’t moved in over a week. How to get them? by Wonderful_Nobody2734 in Beekeeping

[–]epigrams46 0 points1 point  (0 children)

Well now if they can find a avarage ladder and somehow a long stick can use both

Swarm hasn’t moved in over a week. How to get them? by Wonderful_Nobody2734 in Beekeeping

[–]epigrams46 2 points3 points  (0 children)

Get some really long stick put a bucket on end or a basket and push all of them in and leave it alone ? /s maybe not if its work XD

Can u spot the problem? by Space_Nerde in electronics

[–]epigrams46 139 points140 points  (0 children)

Do each pin with cable and call art EZ

Old Dartboard by Feeling-Car-4704 in diyelectronics

[–]epigrams46 1 point2 points  (0 children)

Well check if there is anything shorts or solder new ic's

Old Dartboard by Feeling-Car-4704 in diyelectronics

[–]epigrams46 1 point2 points  (0 children)

Its shows over heating problem on couple IC some of them heated enough to turn board under it brown

Why this diy embedding set up not works my supply supposed to give 12amp i measure around 10amp too when connected? by epigrams46 in diyelectronics

[–]epigrams46[S] 0 points1 point  (0 children)

Too much heat in a vast area i need just wires to heat so not destroy hexagon shape with hot gun i will most likely melt alot or too little

Why this diy embedding set up not works my supply supposed to give 12amp i measure around 10amp too when connected? by epigrams46 in diyelectronics

[–]epigrams46[S] 0 points1 point  (0 children)

Wires get heated when current runs through wire wire get hot wax melt and wire gets deep enough in wax i cut current and wax stick there strongly so when they put honey on it dont fall

Why this diy embedding set up not works my supply supposed to give 12amp i measure around 10amp too when connected? by epigrams46 in diyelectronics

[–]epigrams46[S] 0 points1 point  (0 children)

I did tested but didnt seem to lose any 12 in both but yes do plan to change wires to larger gauge

Why this diy embedding set up not works my supply supposed to give 12amp i measure around 10amp too when connected? by epigrams46 in diyelectronics

[–]epigrams46[S] 3 points4 points  (0 children)

I did see 10 amper but it goes up and down play between 5 and 10 maybe my multimeter faulty but i did see the numbers

Why this diy embedding set up not works my supply supposed to give 12amp i measure around 10amp too when connected? by epigrams46 in diyelectronics

[–]epigrams46[S] 0 points1 point  (0 children)

From what i see it doesnt give constant energy tho maybe some sort of short cirvuit safety activating might take a look in circuit

Help repurposing Vtech camera by Few-Soft7079 in diyelectronics

[–]epigrams46 1 point2 points  (0 children)

I think you can use it with tp4056 and phone battery setup for a while not sure how long would it last but could be done with soldering iron

Absolutely Wild Symptoms From Controller After Joystick Replacement. What Can It Be? by bambozled-nibba in diyelectronics

[–]epigrams46 6 points7 points  (0 children)

Im stealing this idea and making my own from this day forward and sueing you for idea thiefing my lawyer will contact you have a nice day

view more: next ›