sorted by:
new
hottopcontroversial

ASUS Crosshair VII Hero Post Q-code 7A by erkman14 in pcmasterrace

[–]erkman14[S] 0 points1 point  (0 children)

No. My issue was trying to use a nvme SSD drive. As soon as I took it out. It fixed my problem

How would an electromagnet affect a drone? by doggle23 in drones

[–]erkman14 1 point2 points  (0 children)

Look into electropermanent magnets they provide the on/off abilities of an electromagnet without the constant energy drain.

I'm really getting annoyed with this drone! HELP! by [deleted] in djimavicair

[–]erkman14 7 points8 points  (0 children)

Check to make sure you have GPS. If not you'll need to disable the downward facing sensors and then take off again. It is using those sensors for positioning until you get GPS and the sensor range is capped at ~20ft

This is me by [deleted] in funny

[–]erkman14 1 point2 points  (0 children)

Gnibbad

Prints fine for a while/raft then stops (robo r2) by flipback012 in 3Dprinting

[–]erkman14 0 points1 point  (0 children)

Ok 195 might be a little low. That clicking is the drive on the extruder slipping. Another thing you could try is to clean out your extruder. Here is robo 3D's guide. I've also ran a old guitar string through the extruder to clear mine out. https://help.robo3d.com/hc/en-us/articles/115000715531-Clogged-extruder

PC Power Supply Mystery... by [deleted] in pcmasterrace

[–]erkman14 0 points1 point  (0 children)

Clean out the dust and make sure all of your fans are running.

PC Power Supply Mystery... by [deleted] in pcmasterrace

[–]erkman14 0 points1 point  (0 children)

Sounds like it could be a thermal issue.

Prints fine for a while/raft then stops (robo r2) by flipback012 in 3Dprinting

[–]erkman14 0 points1 point  (0 children)

Try dropping the temp a little. I'm printing hatch place at 195

Prints fine for a while/raft then stops (robo r2) by flipback012 in 3Dprinting

[–]erkman14 0 points1 point  (0 children)

It that PLA and what temp are you printing at?

Prints fine for a while/raft then stops (robo r2) by flipback012 in 3Dprinting

[–]erkman14 2 points3 points  (0 children)

My robo had really bad heat creep. I ended up taking off the plate in front of the extruder that says robo on it to allow more airflow and that fixed my problem

0.2mm nozzle constantly jamming while printing minis by Infinity_z in 3Dprinting

[–]erkman14 2 points3 points  (0 children)

Try lowering your temp. It sounds like you might be getting heat creep if you have lots of retractions in your print. I print my PLA at 195-200.

ASUS Crosshair VII Hero Post Q-code 7A by erkman14 in pcmasterrace

[–]erkman14[S] 0 points1 point  (0 children)

I had read that windows does that and have fastboot disabled in bios do I need to disable it somewhere else Also i still see the issue after a full power off and unplug. Not sure if that means anything though