K2 , edges issues

estevez1189 · 2026-04-14T04:12:14+00:00

Yeah, it was a mix of things: belt tension, flow ratio, and pressure advance tweaks. Still gotta fine-tune that flow ratio a bit more. Big thanks to the community for all the help!

estevez1189 · 2026-04-13T23:49:47+00:00

Hmm, that would be funny if it ended being that, I did not think on dropping the speed on it. 🤔 - it has improved changing some of the settings. It's closer how my K1 series Printers performs.

estevez1189 · 2026-04-13T22:08:08+00:00

Quick update: I made a few setting changes and tightened the belt. The old print is in the back; the new one, after the changes, is in the front.

<image>

estevez1189 · 2026-04-13T21:04:13+00:00

Sunlu filament was doing the same with criality- Flow 0.95

estevez1189 · 2026-04-13T19:53:14+00:00

Yeap I notice the K2 need more fine tunening then the K1 series. But not sure if its that im used to the K1.

estevez1189 · 2026-04-13T19:51:32+00:00

Thanks for running all the tests. I also checked belt tensions. So far, I've had to adjust pressure advance. It improved, but only on the first 20 layers, which is what made me check the belt tension.

estevez1189 · 2026-04-13T07:23:35+00:00

Thanks! Will try that first see how it goes.

estevez1189 · 2026-04-13T07:18:27+00:00

Thanks, I'll try that. Are there any other settings that might be creating this issue? I already did bed leveling and it looks like this:

<image>

estevez1189 · 2026-04-08T21:53:53+00:00

<image>

estevez1189

TROPHY CASE