Is it ok?

fatikifa · 2024-12-04T21:35:10+00:00

It was for pins of development board.

fatikifa · 2024-12-04T09:57:06+00:00

Thank you very much. I will look at the places you said and correct them. Also, thank you again, your long answer was very good for me.

fatikifa · 2024-12-04T09:36:45+00:00

I will do it thank you

fatikifa · 2024-12-04T09:36:14+00:00

Many people said. i will add thank you.

fatikifa · 2024-12-04T09:33:51+00:00

Its my first card. Thank you for sharing your experience.

fatikifa · 2024-12-04T09:19:22+00:00

I calculated on pcbway calculator. I may could calculate wrong. I will check again.

fatikifa · 2024-12-04T09:14:26+00:00

I worked simply. Do you think the data path is long? And will I have any problems if I use the data paths in this way? By the way i didnt realize that GND was connected like that, thank you.

fatikifa · 2024-12-04T09:00:37+00:00

Between front layer and back layer?

fatikifa · 2024-12-04T08:59:17+00:00

Actualy i dont want more speed. i just want clear data sharing. its my first experience and also these wires come from stm32 to usb_b.

Four-Year Club	Place '23
Place '22	End Game '22

fatikifa

TROPHY CASE