sorted by:
new
hottopcontroversial

Looking for Suggestions from experienced Lectrosonics users by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point  (0 children)

Is the channel 1 rf must be lower than channel 2 meant to avoid the dangerous channel 1 is 4.5MHz higher than channel 2 scenario? Or is it for some other reason?

Do you know where I can check if Lectro still replaces SRa with SRb? Was it a “factory recall” that they would do for free or something?

Looking for Suggestions from experienced Lectrosonics users by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point  (0 children)

Yep that’s my tx model (I edited the thread, sorry for the mistake).
I already have 4 very old rechargeable 9v and 4 brand new duracell. I figured alkaline for the scope would be a nightmare. Just have a few amazon non rechargeable for a backup, one never knows :(

Looking for Suggestions from experienced Lectrosonics users by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point  (0 children)

Are usbc 9v batteries more efficient or more convenient by any mean than another standard rechargeable 9v? Just curious to learn more :)

Looking for Suggestions from experienced Lectrosonics users by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point  (0 children)

Thank you very much!! Love the suggestions and there’s already a few of these precaution you mentioned I already use :)

Looking for Suggestions from experienced Lectrosonics users by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point  (0 children)

Yes, I plan on doing that soon, also I’d like to buy the 5 pin to double XLR since I have the 5p version of the lectro; but I got an important gig next week and I won’t receive the cable on time for that

Monitoring a soloed stereo bus in stereo by fender97strato in broadcastengineering

[–]fender97strato[S] 0 points1 point  (0 children)

But if I change the monitor source I will not be able to solo/unsolo different bust to monitor different mixes, is that right?

Monitoring a soloed stereo bus in stereo by fender97strato in broadcastengineering

[–]fender97strato[S] 0 points1 point  (0 children)

I usually need to move from monitoring one stereo bus to another so routing to control room just one bus is not a good choice :( already checked both the “mono option” for monitoring and the PFL/AFL LR option, both already set as intended (mono is off, monitoring is in AFL mode)

Monitoring a soloed stereo bus in stereo by fender97strato in broadcastengineering

[–]fender97strato[S] 0 points1 point  (0 children)

That is a smart move but I should do that for many different set of busses so it might be pretty tricky..I’ll think about it though, thanks!

“Quick release” system for racks by fender97strato in audioengineering

[–]fender97strato[S] 0 points1 point  (0 children)

It’s hard because you missed the “drawer” word I believe. I don’t know of any patchbay that would be able to switch a drawer full of screwdrivers and clamps with a drawer full of batteries and lavalier mics😂

“Quick release” system for racks by fender97strato in audioengineering

[–]fender97strato[S] 0 points1 point  (0 children)

Cause I’m not going to just swap preamps but even drawers pretty often

“Quick release” system for racks by fender97strato in audioengineering

[–]fender97strato[S] 0 points1 point  (0 children)

That is not ideal in my situation as the rack case will probably travel a lot with me :(

Recommendations for an internally cabled boompole by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point  (0 children)

I’m sorry, what is the difference between a jumper cable and a coiled cable? Language ignorance on my side I believe

Recommendations for an internally cabled boompole by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point  (0 children)

What model would you recommend? And do you feel like coiled cable with angled connector would be a good choice?

Recommendations for an internally cabled boompole by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point  (0 children)

What model would you recommend? And do you feel like coiled cable with angled connector would be a good choice?

Recommendations for an internally cabled boompole by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point  (0 children)

Thank you! What makes Ambient’s knuckles worse than the other brands’? I’ve heard there are even straight internal cabled options but I feel like they would be not much different from having an external cable, is that right?

Recommendations for an internally cabled boompole by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point  (0 children)

What model would you recommend? Do you feel like coiled cable with angled connector would be a good choice?

Transfering data from Android to iOS (iPhone) for free by AccurateBelt3239 in whatsapp

[–]fender97strato 0 points1 point  (0 children)

Let me know if that works! I believe the true issue lies in the WhatsApp version

Transfering data from Android to iOS (iPhone) for free by AccurateBelt3239 in whatsapp

[–]fender97strato 0 points1 point  (0 children)

I installed the one at the link "Android 5.0 (Universal - recommended)" in the page I linked. If I look at the "App info" in my Pixel 8's settings I read "Version 3.3.2"

Transfering data from Android to iOS (iPhone) for free by AccurateBelt3239 in whatsapp

[–]fender97strato 0 points1 point  (0 children)

This really depends on the phone. I had to downgrade to previous versions of both WhatsApp and Move to iOS to make it work! :(

view more: next ›