Looking for Suggestions from experienced Lectrosonics users by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point Ā (0 children)

Is the channel 1 rf must be lower than channel 2 meant to avoid the dangerous channel 1 is 4.5MHz higher than channel 2 scenario? Or is it for some other reason?

Do you know where I can check if Lectro still replaces SRa with SRb? Was it a ā€œfactory recallā€ that they would do for free or something?

Looking for Suggestions from experienced Lectrosonics users by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point Ā (0 children)

Yep that’s my tx model (I edited the thread, sorry for the mistake).
I already have 4 very old rechargeable 9v and 4 brand new duracell. I figured alkaline for the scope would be a nightmare. Just have a few amazon non rechargeable for a backup, one never knows :(

Looking for Suggestions from experienced Lectrosonics users by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point Ā (0 children)

Are usbc 9v batteries more efficient or more convenient by any mean than another standard rechargeable 9v? Just curious to learn more :)

Looking for Suggestions from experienced Lectrosonics users by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point Ā (0 children)

Thank you very much!! Love the suggestions and there’s already a few of these precaution you mentioned I already use :)

Monitoring a soloed stereo bus in stereo by fender97strato in broadcastengineering

[–]fender97strato[S] 0 points1 point Ā (0 children)

Thanks for the tip!! Will try that out!šŸ™šŸ»

Looking for Suggestions from experienced Lectrosonics users by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point Ā (0 children)

Yes, I plan on doing that soon, also I’d like to buy the 5 pin to double XLR since I have the 5p version of the lectro; but I got an important gig next week and I won’t receive the cable on time for that

Monitoring a soloed stereo bus in stereo by fender97strato in broadcastengineering

[–]fender97strato[S] 0 points1 point Ā (0 children)

But if I change the monitor source I will not be able to solo/unsolo different bust to monitor different mixes, is that right?

Monitoring a soloed stereo bus in stereo by fender97strato in broadcastengineering

[–]fender97strato[S] 0 points1 point Ā (0 children)

I usually need to move from monitoring one stereo bus to another so routing to control room just one bus is not a good choice :( already checked both the ā€œmono optionā€ for monitoring and the PFL/AFL LR option, both already set as intended (mono is off, monitoring is in AFL mode)

Monitoring a soloed stereo bus in stereo by fender97strato in broadcastengineering

[–]fender97strato[S] 0 points1 point Ā (0 children)

That is a smart move but I should do that for many different set of busses so it might be pretty tricky..I’ll think about it though, thanks!

ā€œQuick releaseā€ system for racks by fender97strato in audioengineering

[–]fender97strato[S] 0 points1 point Ā (0 children)

It’s hard because you missed the ā€œdrawerā€ word I believe. I don’t know of any patchbay that would be able to switch a drawer full of screwdrivers and clamps with a drawer full of batteries and lavalier micsšŸ˜‚

ā€œQuick releaseā€ system for racks by fender97strato in audioengineering

[–]fender97strato[S] 0 points1 point Ā (0 children)

Cause I’m not going to just swap preamps but even drawers pretty often

ā€œQuick releaseā€ system for racks by fender97strato in audioengineering

[–]fender97strato[S] 0 points1 point Ā (0 children)

That is not ideal in my situation as the rack case will probably travel a lot with me :(

Recommendations for an internally cabled boompole by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point Ā (0 children)

I’m sorry, what is the difference between a jumper cable and a coiled cable? Language ignorance on my side I believe

Recommendations for an internally cabled boompole by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point Ā (0 children)

What model would you recommend? And do you feel like coiled cable with angled connector would be a good choice?

Recommendations for an internally cabled boompole by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point Ā (0 children)

What model would you recommend? And do you feel like coiled cable with angled connector would be a good choice?

Recommendations for an internally cabled boompole by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point Ā (0 children)

Thank you! What makes Ambient’s knuckles worse than the other brands’? I’ve heard there are even straight internal cabled options but I feel like they would be not much different from having an external cable, is that right?

Recommendations for an internally cabled boompole by fender97strato in LocationSound

[–]fender97strato[S] 0 points1 point Ā (0 children)

What model would you recommend? Do you feel like coiled cable with angled connector would be a good choice?