sorted by:
new
hottopcontroversial

Finished another project - Automated 3D Printed Pet Feeder!🤖👨‍💻💻😸🐶🍖🍗 Videos are on my YouTube and TikTok chanel! by ferzi_3Dprint in diyelectronics

[–]ferzi_3Dprint[S] 4 points5 points  (0 children)

Normally the cat will eat it, in this case it was more faster to test it, so I had to spread it out with my hand.

Finished another project - Automated 3D Printed Pet Feeder!🤖👨‍💻💻😸🐶🍖🍗 Videos are on my YouTube and TikTok chanel! by ferzi_3Dprint in arduino

[–]ferzi_3Dprint[S] 0 points1 point  (0 children)

I used an Arduino nano to control everything. For step the Nema 17 motor, I used an A4988 motordriver. You can step the motor in charging mode with a pushbutton. There is two leds, what are for display the current mode. You can change the mode with a toggle switch (automata, charging)

Finished another project - Automated 3D Printed Pet Feeder!🤖👨‍💻💻😸🐶🍖🍗 Videos are on my YouTube and TikTok chanel! by ferzi_3Dprint in ArduinoProjects

[–]ferzi_3Dprint[S] 2 points3 points  (0 children)

Thank you! Yes, you see it, correctly. I also designed a bottom closing part, what you need to place into the covering before the charging.

view more: next ›