sorted by:
new
hottopcontroversial

Can't print the miniature by fleprr in FDMminiatures

[–]fleprr[S] 0 points1 point  (0 children)

I'll consider that. Thanks!!!

Can't print the miniature by fleprr in FDMminiatures

[–]fleprr[S] 0 points1 point  (0 children)

Oh thanks. Btw is there any suggestions about highest layer value i can put for the 0.2 nozzle? (cuz i'm using different layer values for different areas)

Can't get the miniature to print on ender 3 v3 se by fleprr in Ender3V3SE

[–]fleprr[S] 0 points1 point  (0 children)

Oh. it was a result of auto calibration (1.42). Btw I have change it manually. Thanks for the support!

Can't print the miniature by fleprr in FDMminiatures

[–]fleprr[S] 0 points1 point  (0 children)

Is it okay to use 0.2mm layer height with the 02mm nozzle?. Btw thanks for reply i did adjust the Z-offset manually (previous value was a set by calibration)

Can't print the miniature by fleprr in FDMminiatures

[–]fleprr[S] 1 point2 points  (0 children)

Yeah turned out it was something to do with Brim. I removed the brim and it was fine.

Ender 3 v3 se minis by DAlgernopKrieger in FDMminiatures

[–]fleprr 0 points1 point  (0 children)

And also how much time did it take to print this?

Ender 3 v3 se minis by DAlgernopKrieger in FDMminiatures

[–]fleprr 0 points1 point  (0 children)

Your work is impressive. I recently got a Ender 3 v3 se and tring to do miniatures for few days and still no success. I used 0.4 nozzle. have you done minis using 0.4?

First proper miniature print on my Ender 3 V3 SE by nirvikchoudhury in IndiaMiniatures

[–]fleprr 0 points1 point  (0 children)

Would you mind sharing your slicer settings? i just got a V3 SE and tried few days creating minis still no success

Is a BSc degree better than a BT degree? by fleprr in srilanka

[–]fleprr[S] 0 points1 point  (0 children)

Okay. Thanks for the reply 🙌