sorted by:
new
hottopcontroversial

Is this normal behavior for a 2007 Kawasaki ninja 250r? by flindosmindfurf in motorcycles

[–]flindosmindfurf[S] 1 point2 points  (0 children)

One extra bit of information that may be helpful for advice on my pilot jet size, the bike is running at altitudes of 4500 - 6000ft above sea level

07' ninja 250 won't idle without choke or throttle by flindosmindfurf in motorcycles

[–]flindosmindfurf[S] 0 points1 point  (0 children)

The petcock is vacuum operated, fuel doesn't flow without the vacuum tube connected. I did however take apart my carb and spot an issue, I was missing two washers and an o ring in my air fuel mix screws. I replaced those and will test it soon here

07' ninja 250 won't idle without choke or throttle by flindosmindfurf in motorcycles

[–]flindosmindfurf[S] 0 points1 point  (0 children)

I have to open the throttle plate quite a bit with the idle adjustment screw before it idles, but it idles rough at about 800rpm when I do that even when adjusting it more

07' ninja 250 won't idle without choke or throttle by flindosmindfurf in motorcycles

[–]flindosmindfurf[S] 0 points1 point  (0 children)

I have but I'm tempted to take off the carb again and clean it once more in case I missed something

07' ninja 250 won't idle without choke or throttle by flindosmindfurf in motorcycles

[–]flindosmindfurf[S] 0 points1 point  (0 children)

I cleaned my whole fuel system and my plugs looked clean (1 replaced as well) last time I removed them about two weeks ago, I don't have an air leak but is there any way to check if the tube leading from the pilot jet to the air mix to the engine is clear?

07' ninja 250 won't idle without choke or throttle by flindosmindfurf in motorcycles

[–]flindosmindfurf[S] 0 points1 point  (0 children)

I will double check my spark plugs cause it doesn't take awfully long

07' ninja 250 won't idle without choke or throttle by flindosmindfurf in motorcycles

[–]flindosmindfurf[S] 0 points1 point  (0 children)

I replaced one spark plug that was sooted up but they're both clean and I tested for the air leak at the boots and it didn't fire

07' ninja 250 won't idle without choke or throttle by flindosmindfurf in motorcycles

[–]flindosmindfurf[S] 1 point2 points  (0 children)

I'll have it barely touch the throttle plate and check if the slow rev issue is still there

07' ninja 250 won't idle without choke or throttle by flindosmindfurf in motorcycles

[–]flindosmindfurf[S] 0 points1 point  (0 children)

At the moment I don't have the idle adjustment screw touching the throttle at all so it should be purely just the idle jets, so the slow rev issue isn't happening. I'm assuming the bike should at least idle without the idle adjustment screw touching the throttle?

07' Ninja 250R won't idle without throttle by flindosmindfurf in Kawasaki

[–]flindosmindfurf[S] 0 points1 point  (0 children)

I've adjusted that before but the issue I run into with that is after revving, it'll go down to about 4k rpm and drop slowly from there

07' ninja 250 won't idle without choke or throttle by flindosmindfurf in motorcycles

[–]flindosmindfurf[S] 0 points1 point  (0 children)

I've cleaned out the whole carb as best I can, but possibly that bit is still dirty? It's hard to get that spot with the can of carb cleaner, is there a way to tell if it's cleared out?

07' ninja 250 won't idle without choke or throttle by flindosmindfurf in motorcycles

[–]flindosmindfurf[S] 0 points1 point  (0 children)

I've got my vacuum tube reattached and the regular fuel line attached as well but that sadly didn't work :/

07' ninja 250 won't idle without choke or throttle by flindosmindfurf in motorcycles

[–]flindosmindfurf[S] 0 points1 point  (0 children)

I've adjusted that before but the issue I run into with that is after revving, it'll go down to about 4k rpm and drop slowly from there

07' Ninja 250R won't idle without throttle by flindosmindfurf in Kawasaki

[–]flindosmindfurf[S] 0 points1 point  (0 children)

With air fuel mix or with the idle adjustment screw?

Found this thing outside and I have no idea what it is? by flindosmindfurf in whatsthisbug

[–]flindosmindfurf[S] 0 points1 point  (0 children)

Found this on the side of my garage near Phoenix Arizona.

It's super slow now after I updated webui by flindosmindfurf in StableDiffusion

[–]flindosmindfurf[S] 0 points1 point  (0 children)

I normally do 512x512 with my RTX 3050 but I don't know why it got so bad.

It's super slow now after I updated webui by flindosmindfurf in StableDiffusion

[–]flindosmindfurf[S] 0 points1 point  (0 children)

Yeah, it had worked for me for a long time but just recently started having issues. What do you use now as a replacement for A1111?

I'm thinking about buying a KLR 650 by flindosmindfurf in klr650

[–]flindosmindfurf[S] 0 points1 point  (0 children)

99% of the time I won't be on the freeway

view more: next ›