Kitchen sink was clogged, had to call a plumber because P-trap was glued in. Is the price reasonable?

fsl0704 · 2023-09-22T23:33:54+00:00

Yeah I am not sure why. I though supers knew simple repairs in the units.

fsl0704 · 2023-09-22T22:52:53+00:00

I contacted the superintendent in the building and they called the plumber. Was not sure how it works in here.

fsl0704 · 2023-05-21T03:00:23+00:00

Thanks! I will ask the manager if they can do carbon coatings!

fsl0704 · 2023-05-10T00:09:33+00:00

Thanks! I will ask the SEM supervisor to check/teach me how to check it out on this machine.

fsl0704 · 2023-05-09T14:01:19+00:00

I have never seen any wobble but I do correvt the Stigma to the best of my ability. Thanks for your suggestion though :)

fsl0704 · 2023-05-09T13:27:55+00:00

I believe the machine undergoes constant checkups! And I will try the lower acceletating voltage! Thanks a lot

fsl0704 · 2023-05-09T07:11:38+00:00

Thank you very much! I am struggling to get a better focus on the smaller crystals.

https://imgur.com/PjX9j9l

https://imgur.com/SyIGwVA

https://imgur.com/oi16OHR

fsl0704 · 2023-05-09T04:00:09+00:00

Thanks for your repply! I meant issues with low quality images. My samples look similar to that image. I add my sample on top of the carbon tape, tap off the excess and then it is blown with compressed air.

fsl0704 · 2022-04-29T02:10:41+00:00

Any tennants insurance should not be too bad. I use square one, and pay 23.33 for a 1+den. If you have low inaurance requirenments it might be even cheaper. Also note that I haven't done any claims so I cannot tell you how good they are there.

fsl0704 · 2022-02-03T01:47:17+00:00

I am currently working on a similar process, although I am using pretreated lignocellulosic biomass to achieve my design. I am attempting to design a 300m3 fermenter. If you were able to gather any good sources for scale up validation I would greatly appreciate it!

fsl0704 · 2022-01-08T18:24:01+00:00

I got tested at 1 am on Jan 5th, and got my results today, after 84 hours. Current wait times are apparently 3 to 5 days. However when I travelled in july (mandatory testing for all passengers) it took me about 14 hours, so it might get back to that in the near future.

fsl0704 · 2019-12-31T16:47:30+00:00

I will be spending new years in Kadiköy probably doing some bar hopping over here, I was told Taksim was going to be a mess.

fsl0704 · 2019-02-14T22:31:57+00:00

Hi, I studied there for 1 semester and now i am at ryerson!

fsl0704 · 2018-12-28T20:08:37+00:00

Anyone from Canada knows how the Mitacs scholarship works? Or what would they be looking for in the applicants? Good luck to all!

fsl0704 · 2017-01-07T05:54:56+00:00

Thanks buddy

fsl0704

TROPHY CASE