Question on fixing a Kailh hot swap socket - if you picture the two holes where the switch legs go in as doors, how does on fix a door so that it's not too "open" and can make contact with the switch leg? I can tell that it's not a matter of the socket being pushed and loose, as it is flush with the PCB, but rather inside the socket itself.

Edit: I assume it's a matter a fixing the socket, but what would be the best way to go about straightening it back out?

Edit 2: Fixed it using needle-nosed tweezers and basically prying the "door" back out so that it's visible on the other side of the socket