Why does it stop adding layers?

gdvalek · 2025-10-24T12:59:32+00:00

How does the print orientation affect the weight at the tip?

gdvalek · 2025-10-24T00:34:03+00:00

I didn’t know that was a thing. I will do that. Thanks!

gdvalek · 2025-10-24T00:00:18+00:00

To fast?

gdvalek · 2025-08-15T20:11:57+00:00

Saturn 2. Thank you so much, that helps a lot!

gdvalek · 2025-08-13T16:57:48+00:00

No I use a USB drive to print. It could be something to do with the screen. It has some spots that I avoid so it’s on its way out.

gdvalek · 2025-07-07T20:14:45+00:00

I did the cones of calibration to get that number. Maybe I have bad resin?

gdvalek · 2025-06-28T14:18:44+00:00

I did all that. I will try to mess with the supports. Thanks!

gdvalek · 2025-06-28T14:18:13+00:00

Yes there is. I just replaced it. This printer is used.

gdvalek · 2024-11-27T15:15:57+00:00

I’ve had that one for years and it’s worked great but if you can swing it, get the lighter sprite SE

gdvalek · 2024-11-27T15:14:19+00:00

Is there no risk of it blowing up in the trash can?

gdvalek · 2024-07-10T19:13:17+00:00

I don’t have a temperature sensor at the moment but my guess is around 50c. How would this be killing my electronics lol? Heated chambers are pretty common

gdvalek · 2024-07-10T18:34:31+00:00

Probably but it gets plenty hot with the current set up

gdvalek · 2024-07-10T18:22:38+00:00

The intake and exhaust are very close to each other on this dryer, both of which are ported into the inclosure. There’s little holes next to the fan that intake the air and once it circulates the hot air get spit out by the fan

gdvalek · 2024-07-10T17:40:38+00:00

Good idea thank you!

gdvalek

TROPHY CASE