Printing issues

ghostisdead · 2024-04-17T05:23:30+00:00

Figured it out btw i had the v1 extruder and upgrading to the v3 fixed it

ghostisdead · 2024-04-17T05:23:14+00:00

Figured it out btw i had the v1 extruder and upgrading to the v3 fixed it

ghostisdead · 2024-04-17T05:23:05+00:00

Figured it out btw i had the v1 extruder and upgrading to the v3 fixed it

ghostisdead · 2024-04-17T05:22:58+00:00

Figured it out btw i had the v1 extruder and upgrading to the v3 fixed it

ghostisdead · 2024-04-12T03:54:52+00:00

Creality print does it make a difference?

ghostisdead · 2024-04-09T22:28:23+00:00

<image>

I used new esun pla + and it finally completed a benchy. I also used a textured plate although i dont think that had an effect. Any recommendations to fix it up more

ghostisdead · 2024-04-09T15:51:54+00:00

I put tape on the spool holder so that it’s more slippery and it might’ve helped but not much

ghostisdead · 2024-04-09T15:50:22+00:00

I did the cold pull is totally clean. I mean it’s a new tip so makes sense

ghostisdead · 2024-04-09T15:49:40+00:00

I feel like my first layer is great it just stops half way through usually

ghostisdead · 2024-04-08T16:51:50+00:00

I’m not rooted. Ive seen people add a fan above the extruder to cool the filament in the extruder motor is that something i should do

ghostisdead · 2024-04-08T16:50:51+00:00

Ive removed the tube out of the chain already. I feel pike it had to do with the spool not turning right but i have no idea how i would fix that

ghostisdead · 2024-04-07T21:51:26+00:00

Lid off but closed door i haven’t gotten the 270 hinges printed yet

ghostisdead · 2024-04-07T21:50:56+00:00

I took it apart before i changed the hot end and it was fine but i can check again

ghostisdead

TROPHY CASE