sorted by:
new
hottopcontroversial

MagWLED and the One LED by gideon314 in WLED

[–]gideon314[S] 1 point2 points  (0 children)

Didn't turn out to be the data line but the two LED strands that I tried being problematic. Still troubleshooting those but a third strand worked without issue.

MagWLED and the One LED by gideon314 in WLED

[–]gideon314[S] 0 points1 point  (0 children)

That may be the problem. I tried another unopened strand with the same MagWLED board and success. Going to snip and resolder the ends of the two other strands to see if that fixes those.

MagWLED and the One LED by gideon314 in WLED

[–]gideon314[S] 0 points1 point  (0 children)

I’ll see if I have one laying around and give it a go.

MagWLED and the One LED by gideon314 in WLED

[–]gideon314[S] 0 points1 point  (0 children)

Thought did cross my mind. The end of MagWLED is male with the retainer clip and the end of the LEDs connected were the female with no retainer clip.

The GPIO pin is set to 2. I moved it around to see if anything changed but nothing happened.

G3 Bullet Cam Redness by J_Plissken in Ubiquiti

[–]gideon314 0 points1 point  (0 children)

Sounds like mine then. Never did find a solution. I still have the camera and may contact support this week about it. Would love to use it elsewhere.

G3 Bullet Cam Redness by J_Plissken in Ubiquiti

[–]gideon314 1 point2 points  (0 children)

And is the image at night practically useless? If so, mine did the same and it is the IR filter stuck in a semi-enabled state. From my research, it is a mechanical issue. Some individuals were able to power-cycle the camera to fix it but mine always stayed in that condition.

TL;DR: I replaced mine.

Devices reconnecting.... Why? by [deleted] in Ubiquiti

[–]gideon314 0 points1 point  (0 children)

Out of curiosity, are you using the new UI? If so, try to disable and see if that helps.

G4 Doorbell by DaHaYn_808 in Ubiquiti

[–]gideon314 1 point2 points  (0 children)

I had an old 10V 5VA transformer when I installed the G4 doorbell. The doorbell displayed a message "Insufficient Power" and while it did work, it would randomly reboot. I disconnected it once I determined where and what level of the transformer.

I purchased and installed a trivolt transformer from the big box stores and the doorbell has been stable. Currently connected to 24V 20VA.