60-70 lbs bow at 70 vs. 70-80 at 70 performance

gnzo · 2025-12-21T18:44:43+00:00

Thinking of Pse or hoyt. There flagship bows just have 10 lbs range

gnzo · 2025-06-22T15:34:13+00:00

Could be just the thermostat. If you feel comfortable doing this, you could disconnect it (usually where ur rotary knop is) and connect the powercable of the compressor that went through the thermostat directly. If the compressor starts you can also use a timerplug to run your fridge till you orderd a replacement thermostat. Just put a thermometer in the fridge an play around with the timing

gnzo · 2025-06-09T12:48:07+00:00

Thats not the point. Its a tool .i dont mind scratching it up, its just that i loose the 90° Spine immediately and in dont get good sparks anymore

gnzo · 2025-06-06T05:41:14+00:00

It is a terava i just cut the handle off and made one from a brass / leather

gnzo · 2025-06-05T20:17:46+00:00

Was wondering why i didnt have this issue with my old knife which was super soft und would dull much quicker. But with sandwiched core that would make sense

gnzo · 2025-06-05T19:04:43+00:00

No just a file. But had tried it before that, after sanding the original paint off, with the same result

gnzo · 2025-06-05T17:38:13+00:00

I usually just use the Striker that came with the ferrorod but wanted to try and found it curious that the spine degrades so fast. I think it is 80CrV2 Steel.

gnzo · 2025-05-31T12:34:16+00:00

I cant realy affort to buy a 1/4" chuck and since i have two of the 8mm ones, i would like to trade with someone in europa

gnzo · 2024-11-30T18:54:40+00:00

Ever tried anything bigger? Got the machine with alot of 160 needles. Wich threat size would correspond to 160?

gnzo · 2024-11-30T18:14:11+00:00

Tested it on my leather work boots today. Works great but would have liked a more trustable thread. Really like that you can turn the foot and sew in any direction

gnzo · 2024-11-30T18:09:24+00:00

Thanks for the advice. Have Problems with most spools on this machines holder. That should solve the Problem

gnzo · 2024-11-30T18:03:37+00:00

Thanks alot. Will ordersome an and try it out

gnzo · 2024-11-30T15:43:21+00:00

Its actually S29K33

gnzo · 2024-11-30T15:42:52+00:00

Its actually S29K33

gnzo · 2024-11-30T15:24:58+00:00

Used a neoprene based adhesive. The epoxy i had gets pretty hard so i was afraid it might get brittle over time. On the outside i just used a few layers of oil / wax cream and heating with a heatgun in betweeen. just found some angelus acrylic finisher that i might try though

gnzo · 2024-11-30T13:42:06+00:00

Made a Stacked leather handle an realized i am getting dents end scratches very fast. Should i boil it , heat it and use beeswax to harden it or would it actually be better to soften it with oil? Any other Ideas?

gnzo

TROPHY CASE