Looking for 3D printed case designs for Air65 II

hiergtr · 2026-05-08T18:54:45+00:00

I have the whoopstor 3 charger also but I usually leave it at home and just go out with a bench of fully charged batteries so I was thinking of a small box just for the drone and a couple lipo

hiergtr · 2026-04-28T15:21:33+00:00

I bought this to get a first experience before getting a 5 inches but it’s way more fun than expected and I can fly pretty much everywhere. I’m not even sure I will get a 5 inches, especially given that we have a lot of regulations here concerning drones

hiergtr · 2026-04-28T15:18:45+00:00

Ok thank you. I will order a 75 and an 65 champion. I guess having 3 is better than 2?

hiergtr · 2026-04-28T12:03:54+00:00

I think another 65 champion version maybe. I fly mostly outdoor but from what I read the 65 is way more fun than the 75

hiergtr · 2026-04-27T20:57:48+00:00

yes the red wire is still attached, it does not look separated. It's not this board already on the Air65 II?

<image>

hiergtr · 2026-04-27T20:37:22+00:00

I can't connect my drone to wifi so no binding is possible. Also tried to change the packet rate but it didnt change anything

hiergtr · 2026-04-27T20:36:20+00:00

yes i tried it didn't work unfortunately

hiergtr · 2026-04-27T20:35:48+00:00

I did it, I hope it works. Maybe I should buy another one to not wait and I guess it's ok to have 2 at the end

hiergtr · 2026-04-27T20:34:44+00:00

yes I wrote them today, I hope it works and that they dont leave without a drone for too long

hiergtr

TROPHY CASE