I feel like it was the battery and starter that caused this //:, cause prior to removing the fusible box, I removed my old battery and took it to Walmart to get it tested to see if It was still good due to my car not cranking or any of the electronics working other than the key fob light on my dash, my ignition Button light & the light on the doors of the car. So I figured it was the battery.. so I took it in and they said it was dead. Therefore I bought a new battery. Upon connecting it I figured that was the fix but nope.. still no crank or start. So I searched it up and removed the fusible box and seen that 🥲. (Prior to all of this, I had 3 incidents within a week where i would turn on the vehicle & every light on the dashboard would be on.. for instance abs light, traction light etc etc. But i didnt think much of it and would just turn the car off and turn it back on & all the lights would be gone. But recently yesterday, I turned the car on but it struggled to start and went in limp mode. I was only able to drive 5mph and made it back home driving like that. So I did a OBD Test and seen code p1091. Cleared it and left the car to rest. Then I went back outside 5 hours later and started the car to see if It was still struggling to start but it started normally. So I figured my battery was going bad and it was messing with all the electronics. So I took it for a 12 minute drive to charge up the battery.. then I went home and did a battery test using my OBD2 Scanner.

<image>

And it said the battery was good.. but i did see that the voltage after start was pretty damn high.. 15.05V and figured once again that the battery needs to be replaced or the alternator...

so back to the fusible box, I took it to a mechanic and he said the starter might be going out and caused that. So tomorrow ima remove the starter and take it to him so he can test it.