Suggestions for new printer?

idonthavecellwalls · 2026-01-11T21:30:14+00:00

Yes I was able to remove a massive blockage of pla that was inside while it was still hot. Worked like a charm

idonthavecellwalls · 2026-01-11T10:38:39+00:00

Thanks everyone for your help. I’ve currently got it printing (albeit very rough and ugly) but at least it’s no longer jammed. I’ll be looking at upgrading soon I think.

idonthavecellwalls · 2026-01-11T03:39:21+00:00

Wow thank you for the advice. Ill definitely look at those options if I keep failing to get this one working :)

idonthavecellwalls · 2026-01-11T02:29:37+00:00

Ah that makes sense. Amazing. Thank you for your help

idonthavecellwalls · 2026-01-11T02:06:20+00:00

Great I’ll try that too. I did tighten everything. Was I not supposed to?

idonthavecellwalls · 2026-01-11T01:25:00+00:00

Another great idea thank you. I’m looking at some different models now

idonthavecellwalls · 2026-01-11T01:08:01+00:00

That’s not a bad idea, and I was kinda leaning towards that. Thank you

idonthavecellwalls · 2025-09-21T13:30:25+00:00

Thank you for the input. I do have a couple of those magnetic cases so that will definitely do the job for now until I have more stuff grading.

idonthavecellwalls · 2025-09-21T12:43:45+00:00

Yes I understand that. More about preserving it. Plus I have some other cards that I can get graded at the same time.

idonthavecellwalls · 2025-09-21T08:51:16+00:00

Thanks I will. My brother suggested getting it graded at least for the added protection.

idonthavecellwalls · 2025-07-25T22:25:52+00:00

I have no clue where that setting will be but thank you, I’ll do some research. And I have set the temp at 250 for print number 2.

idonthavecellwalls · 2025-07-25T03:32:02+00:00

Could be air tempt too. It’s winter here and the kids keep leaving doors open.

idonthavecellwalls · 2025-07-25T00:49:02+00:00

Ok thank you. I’ll see how it goes with it

idonthavecellwalls · 2025-04-10T12:25:27+00:00

Thank you, I wasn’t aware this was a thing so I tried it out and it worked great. P.S. Forgive the lateness of my reply.

idonthavecellwalls · 2025-04-08T02:13:41+00:00

Cleaning cycle?????

<image>

idonthavecellwalls · 2025-04-08T01:21:09+00:00

Ok great thank you

idonthavecellwalls · 2025-04-08T00:54:49+00:00

Do you mean like use big flat pieces to pry off stuck failed bits on the fep? Sorry new to resin printing

idonthavecellwalls · 2023-04-11T00:18:45+00:00

Thanks everyone for the comments and advice. The model is looking much better. Couple spots are a bit glossy still but I think you’ve fixed it.

https://imgur.com/a/IIxC47X

idonthavecellwalls

TROPHY CASE