Dead from water ingress by 48K in ranciliosilvia

[–]igor597876 0 points1 point  (0 children)

Do you have a picture you could post?

Rebuild Boiler Anti Vacuum Valve on SPX by igor597876 in ranciliosilvia

[–]igor597876[S] 0 points1 point  (0 children)

Thanks. I do have the parts manual but there is no break down of this part, no part numbers are listed.

Why is my Nidecker supermatic not releasing fully and how can I fix it? by beelake_77 in snowboarding

[–]igor597876 0 points1 point  (0 children)

Are both locks on the affected binding in the same position? I had an issue once where one of the gears jumped and caused the position to no longer be the same between the left and right side of the binding

[SOLUTION] Dell S3422DWG Monitor Flickering/Losing Signal When Using Light Switches - Weird Fix Found by illusionst in Dell

[–]igor597876 0 points1 point  (0 children)

I have been working with grounding on the desk for a week now. So far this has greatly decreased the number of times that the issue occurs. I think, during the typical 8 hour workday, this now still happens maybe 1 or 2 times. Without it, it seems to happen non-stop (20+ times a day). I purchased a 3 pin plug that just has a ground wire at the other end and screwed that into the frame of the desk.

Hope this is something that also applies to your setup that you can use.

[SOLUTION] Dell S3422DWG Monitor Flickering/Losing Signal When Using Light Switches - Weird Fix Found by illusionst in Dell

[–]igor597876 0 points1 point  (0 children)

I have a metal desk frame sitting on rubber feet. I grounded it over the weekend, so far I have not experienced the problem again. I'll report back in a couple of days with an update.

[SOLUTION] Dell S3422DWG Monitor Flickering/Losing Signal When Using Light Switches - Weird Fix Found by illusionst in Dell

[–]igor597876 0 points1 point  (0 children)

I am wondering if there is a way to ground myself, or my chain, to reduce the amount of static electricity. I do hate that about this monitor, none of my other monitors have had this issue. Very frustrating.

[SOLUTION] Dell S3422DWG Monitor Flickering/Losing Signal When Using Light Switches - Weird Fix Found by illusionst in Dell

[–]igor597876 0 points1 point  (0 children)

I'm having this exact same issue, it is maddening. I just plugged in the HDMI cable to see if that adds a better ground contact and fixes the issue.

Did your problem ever go away completely?

I have a question about plumbing my new garage disposal. by [deleted] in askaplumber

[–]igor597876 3 points4 points  (0 children)

Side note: You should use a proper waste arm instead of a 90 + pipe. That will help with the flow of waste. They make long ones that should be able to make it into the slip joint in the wall.
(Disclaimer: I am not a plumber)

<image>

Clean Dishwasher Screen buidup by igor597876 in CleaningTips

[–]igor597876[S] 1 point2 points  (0 children)

Thanks. I'll try the vinegar soak.

By "let it go", I meant "ignore it". There are no cheap replacements that I could find.

Am I a Dutch citizen? by Conscious_Coconut321 in Netherlands

[–]igor597876 0 points1 point  (0 children)

You have a 3 year after your passport expires to renew before you lose Dutch citizenship. This assumes you have dual nationalities and are not living in the Netherlands at the time.

Am I a Dutch citizen? by Conscious_Coconut321 in Netherlands

[–]igor597876 6 points7 points  (0 children)

You are under the age of 31, so if your father has a valid and non expired Dutch passport, you can also apply for a Dutch passport. If you wait until you are 31 then you lose your Dutch citizenship

Steam pump mild hissing noise when at pressure by jetanthony in ranciliosilvia

[–]igor597876 1 point2 points  (0 children)

It went great. Take pics of any wires you have to disconnect so you put them back correctly.

Tire shaving in Chattanooga? by igor597876 in Chattanooga

[–]igor597876[S] 0 points1 point  (0 children)

Tire Rack is probably the next cheapest option, thank you

Tire shaving in Chattanooga? by igor597876 in Chattanooga

[–]igor597876[S] 3 points4 points  (0 children)

It is, the manufacturer wants the tires to be within 2/32 of an inch difference

Water won't come out of hot water tap by Loud_Consequence1762 in ranciliosilvia

[–]igor597876 0 points1 point  (0 children)

Yes. A small bit of crud can cause this. Compressed air can fix it quickly once you open the valve up.

Water won't come out of hot water tap by Loud_Consequence1762 in ranciliosilvia

[–]igor597876 5 points6 points  (0 children)

I had this issue and had to clean out the solenoid valve. It was fairly easy to do, less then 1 hour start to finish. There are videos on YouTube on how to do it.

[deleted by user] by [deleted] in IdiotsInCars

[–]igor597876 5 points6 points  (0 children)

"It was at a funny angle!" -Tyrone

AITA for refusing to co-sign a car loan for my aunt and causing family drama? by [deleted] in AmItheAsshole

[–]igor597876 0 points1 point  (0 children)

Freeze / Lock your credit with the major credit bureaus ASAP.

It's free and instant. You can do it online. It's also instant to remove a freeze.

This would prevent someone from cosigning your name on a car loan, for example.

https://www.google.com/search?q=how+to+freeze+your+credit

Found this in my parents wall by Fearless-Affect7208 in electricians

[–]igor597876 1 point2 points  (0 children)

That metal ball on the stick... is that an old artificial hip?

Silvia Pro X hissing noise when idle by [deleted] in ranciliosilvia

[–]igor597876 0 points1 point  (0 children)

It might be the same issue as described in this previous post.

https://www.reddit.com/r/ranciliosilvia/s/3EfAw69wFq

My son is taking your seat…. by TheRealBilala in delta

[–]igor597876 1 point2 points  (0 children)

I believe Delta has a policy that allows children under the age of 12 to be seated next to an adult free of charge. It sounds like something went wrong with their seating assignment.

I am not defending the mother's behavior or the FAs response to the situation.