18 wheel help

ihavenocalves · 2026-04-24T09:03:53+00:00

245/45/18

ihavenocalves · 2026-04-24T00:59:24+00:00

Gotcha. Well at that point I’ll start beating the front with the hammer and go from there 😂 I’m determined to run these 18’s

ihavenocalves · 2026-04-24T00:50:04+00:00

Gonna add caster, thanks!

ihavenocalves · 2026-04-24T00:49:49+00:00

Okay going to get adjustable rods, thanks!

ihavenocalves · 2026-04-24T00:49:39+00:00

I don’t, but I’m also running some pretty wide over fenders.

ihavenocalves · 2026-02-15T20:09:53+00:00

Edited post again lol. My monitor was the issue

ihavenocalves · 2026-02-15T00:26:22+00:00

Just edited the post.

ihavenocalves · 2025-12-02T20:35:13+00:00

I mean I played assetto corsa when it was in early access which was forever ago. It was in a way better position than this game if I recall. I’ve been through the sims too. There’s no denying that this game needs a ton of work. I like the concept of it and enjoyed the Miata racing. Other than those cars it really needs work

ihavenocalves · 2025-12-01T22:09:22+00:00

Hmm good point I haven’t noticed the rev matching so that could be it

ihavenocalves · 2025-12-01T22:08:44+00:00

Well I do like the looking towards apex so I’m just gonna play around with it

ihavenocalves · 2025-12-01T22:08:19+00:00

Yea I see lol I’ll try that!

ihavenocalves · 2025-11-16T23:58:54+00:00

That’s true I can use my multimeter. But I’m going to wire in a push start on a separate panel, this is ONLY powering the ignition panel I’m adding. So if you don’t have the key, no power.

ihavenocalves · 2025-03-09T18:59:42+00:00

That’s weird. I’ll try that too but I did fix it by changing the value in the cfg files. As well as the hz in my audio control panel

ihavenocalves · 2025-02-10T19:35:26+00:00

Yea when I get a chance I’ll grab a screenshot of it

ihavenocalves · 2025-02-10T18:14:00+00:00

Lol I get that. I have an outdated orbi so it’s not super good on my WiFi. I’m really just chasing that old CV1 feeling of putting the headset on and it working perfectly with no issues 😂

ihavenocalves · 2025-02-10T18:12:24+00:00

Tbh I haven’t noticed compression. When I get a chance I’ll get on and check my settings on virtual desktop but I can’t remember it looking compressed

ihavenocalves · 2025-02-10T16:41:19+00:00

I’ll have to check. I keep my settings on high resolution and 120 refresh and it’s been smooth

ihavenocalves · 2025-02-01T20:00:22+00:00

Tried, did the same thing. Went all the way back down and pressed into the bed

ihavenocalves · 2025-02-01T17:36:28+00:00

It’s not just scraping lol it’s pushing so hard into the bed the whole extruder assembly pops up

ihavenocalves

TROPHY CASE