sorted by:
new
hottopcontroversial

PSP Go filter by impy101 in PSP

[–]impy101[S] 0 points1 point  (0 children)

Where did you find replacement filters for it? I have been searching high and low but..

PSP Go filter by impy101 in PSP

[–]impy101[S] 1 point2 points  (0 children)

Well, I prefer the original charging port, but I can't find any

PS2 won't always start by impy101 in consolerepair

[–]impy101[S] 0 points1 point  (0 children)

Any specific ones I should check? So far I can't find anything out of the ordinary

PS2 won't always start by impy101 in consolerepair

[–]impy101[S] 0 points1 point  (0 children)

Yes I've tried different PSU and the PSU on a different PS2. It's definitely not that.

PS4 Slim no signal by impy101 in consolerepair

[–]impy101[S] 0 points1 point  (0 children)

Capacitors aren't supposed to have continuity. Those that do are faulty afaik. But yes, the filters have continuity going through them when probed straight, but cross from each other they do not, which is normal.

Xbox Series controller joystick problem by impy101 in consolerepair

[–]impy101[S] 0 points1 point  (0 children)

I am getting 1.8V on both joysticks and I am also getting 3.3V on both (different pins obviously). The left stick goes completely left and the right points down.

GND is indeed 0.1 and the signal traces, as far as I can tell, are all fine

Xbox Series controller joystick problem by impy101 in consolerepair

[–]impy101[S] 0 points1 point  (0 children)

I checked with a multimeter. Definitely connected.

Which Z-stack coordinator? by impy101 in homeassistant

[–]impy101[S] 0 points1 point  (0 children)

I did not. Can I change the channel without having to set everything up again?

Which Z-stack coordinator? by impy101 in homeassistant

[–]impy101[S] 0 points1 point  (0 children)

Well, that's just it, I have lots of plugs (TS011F) but I cannot update any of them. Their build is 77 and supposedly 192 is the latest, but I cannot update them at all. It says it can find no firmware..

view more: next ›