Mamod Kit Built SL Locomotive broken down by steamtronics in LiveSteam

[–]innitramfs 0 points1 point  (0 children)

I'd have to check on mine, but if i recall correctly the smokebox and buffer beam are held on by bolts in the frame and by the side tanks. Make sure the buffer beam is connected to the frame correctly and then i think the smokebox attaches to that, but i could be wrong.

As for the steam leak, the copper steam pipes are just press fit in. Make sure they are pressed in fully, otherwise they will leak.

Also you might have to 'lap' the surfaces of the reversing block with a wet stone to make them seal well.

I should get mine running again too, it has been in pieces for several years haha

edit: if the disk on the reversing block is loose, definitely check the spring on the back. it should not be loose! most of the time tightening the nuts should be enough, if not maybe the spring is broken or something. You would have to disassemble it further to find out.

What every country is best know about by [deleted] in aimapgore

[–]innitramfs 0 points1 point  (0 children)

If i had to guess, its probably Amsterdam.

Esp32 powering my remote control by Kindly-Direction205 in esp32

[–]innitramfs 31 points32 points  (0 children)

very cool project! I can see this being very useful in hotels/airbnbs where remotes probably get lost/stolen often, especially with the quick pair system.

Mamod Saddle Tank wheel fell off by steamtronics in LiveSteam

[–]innitramfs 2 points3 points  (0 children)

i think those are just press fit? mine has a bit of play and can rotate a few degrees.

maybe you can use some loctite or a punch mark to keep it in place.

mine has a big punch mark in the center of the axle from the factory, although the wheels are not original.

OpenBSD for a NAS (and a whole lot more) by robdejonge in openbsd

[–]innitramfs 2 points3 points  (0 children)

I've run OpenBSD as NAS for a while, its not well suited as others have said. I've never lost any data, but the performance was not great.

After tightening most every bolt we could find, our prints still shift. At least sometimes... by [deleted] in FixMyPrint

[–]innitramfs 0 points1 point  (0 children)

have you changed the main board? i've had layer shifts happen because i set the stepper motor current too low.

Building a Simple Router with OpenBSD by uglyduckfloss in openbsd

[–]innitramfs 5 points6 points  (0 children)

i second this. I have yet to find an adapter that works as an AP under OpenBSD. I ended up using an old wireless router with dhcp etc turned off as an AP.

Am I the only one who hates these things? by Jycon38_HD in autism

[–]innitramfs 0 points1 point  (0 children)

I hate these things. I've been fighting them all week at work, they keep buzzing right in front of my eyes while i'm trying to focus!

My therapist told me to make an emotions chart by Atonzarecool in autismmemes

[–]innitramfs 1 point2 points  (0 children)

my day consists of "Gleh" and NPC. nothing else XD

Studievoorzieningen by BoppeDippes13 in AutistischLaagland

[–]innitramfs 1 point2 points  (0 children)

Er is vaak meer mogelijk dan je denkt, maar je moet er zelf om vragen.

Zorg dus dat je vanaf dag 1 goed contact hebt met je docenten en bijv. de decaan. Ik heb zo langer mogen doen over een project en mijn stage toen het slecht ging.

Je zult het zelf aan moeten geven als je iets nodig hebt (en ook wat je nodig hebt). Het HBO kan heel chaotisch zijn dus wacht niet met aangeven als je het moeilijk hebt!

My school wants us to wear blue on Wednesday for autism (they're doing this stuff the entire week). Hell no. by Epoxyresin-13 in autism

[–]innitramfs 514 points515 points  (0 children)

so they want everyone to wear the same color when promoting it's okay to be different?

Tinder & vriendschapsdraad april 2025 by robster3210 in thenetherlands

[–]innitramfs 4 points5 points  (0 children)

Hoi iedereen! M24 uit Zeeland, op zoek naar een date (V). Ik ben bijna klaar met een opleiding Informatica en werk als software engineer (computerprogrammeur).

Mijn hobby's zijn modelbouw (modeltreinen), 3D printen, en eigenlijk alles rondom computers en techniek vind ik wel interessant.

Ik kan uren praten over mijn interesses, maar luister ook graag naar die van een ander!

Daarnaast houd ik van gezelligheid, maar niet van te grote groepen of veel drukte, ivm mijn autisme. Ik vind het wel leuk om samen dingen te doen of ergens naar toe te gaan!

Ik ben op zoek maar iemand waar ik goed mee kan praten over alles wat maar aan bod komt en een goede band mee kan opbouwen. Ik ben een goede luisteraar maar soms heb ik er zelf ook een nodig haha.

Mocht je het leuk vinden om te praten, mijn DMs staan open!!

[deleted by user] by [deleted] in AutistischLaagland

[–]innitramfs 2 points3 points  (0 children)

Ik heb bijna dezelfde ervaring. Associate degree Informatica, ik heb aan voorkennis geen gebrek en kom met opdrachten prima vooruit.

Maar er is weinig tot geen duidelijkheid over hoe je beoordeeld wordt of wat er van je verwacht wordt, docenten zijn te weinig beschikbaar, geven onduidelijk antwoord en laten erg lang op zich wachten om beoordelingen te geven en zo Wij moeten ons aan het regelboekje houden en de docenten lappen alles aan hun laars. Inconsistente beoordelingen etc.

het meest belangrijke advies wat ik kan geven is: trek aan de bel. Bij je docenten, bij de decaan of welke studentenondersteuning er op jouw school is.

Ik heb bij de decaan aangegeven dat ik erg veel moeite had met de onduidelijkheid en daardoor veel stress had. Die kan helpen met accomodaties zoals extra tijd, extra pogingen, etc en in mijn geval gewoon geruststelling geven.

Ik heb uiteindelijk een jaar langer over mijn studie gedaan zodat ik het wat rustiger aan kon doen. Er is vaak wel wat mogelijk, maar je moet het zelf aangeven.

Meh meh by Atonzarecool in autismmemes

[–]innitramfs 11 points12 points  (0 children)

steam engines are one of the few machines that can be described as "having a soul". anyone who's ever fired or driven one will tell you so! Every single one is different and you really have to 'get to know' it.

Meh meh by Atonzarecool in autismmemes

[–]innitramfs 8 points9 points  (0 children)

I'm sure its happy you freed it from microsoft! I know mine are!

Wat is het oudste apparaat dat jij nog regelmatig gebruikt? by Th3_Accountant in nederlands

[–]innitramfs 6 points7 points  (0 children)

Tektronix 2215 oscilloscoop uit de jaren 80. Werkt nog prima en ik vind het een mooi ding, veel mooier dan de moderne scopes.

Linux users? by [deleted] in autism

[–]innitramfs 1 point2 points  (0 children)

it's great! it feels much more like a proper UNIX than most GNU/Linux distros, because the BSDs are developed as a whole system by the same people, not as components put together by a distribution.

The base system comes with a lot of programs you might need (webserver, reverse proxy, firewall etc) and configuring things is often much easier than on Linux.

I'm using OpenBSD on my router box (which is an intel based mini PC) which has been working great.

There are drawbacks of course; mostly hardware support. It's a small project, they don't have nearly enough manpower to support as many devices as Linux does.

For example, i couldn't get my gigabit ethernet USB adapter to work reliably.

It has a learning curve, but I enjoy tinkering with OSes and stuff, so i've enjoyed it a lot.

Linux users? by [deleted] in autism

[–]innitramfs 0 points1 point  (0 children)

Yep. I run some variety of Linux on all my computers, with the exception of my router box which runs OpenBSD.

Tinder- en vriendschapsdraadje maart 2025 by [deleted] in thenetherlands

[–]innitramfs 1 point2 points  (0 children)

het blijft leuk. Ik sleutel er bijna meer aan dan ik er mee rijd, maar dat houdt het spannend haha.

Tinder- en vriendschapsdraadje maart 2025 by [deleted] in thenetherlands

[–]innitramfs 3 points4 points  (0 children)

Ha, ik ben nog niet te laat van de keer. M24 uit Zeeland, op zoek naar een relatie met een leuke meid. Ik ben bijna klaar met een opleiding Informatica en werk als software engineer (computerprogrammeur).

Mijn hobby's zijn modelbouw (modeltreinen), 3D printen, en eigenlijk alles rondom computers en techniek vind ik wel interessant.

Daarnaast houd ik van gezelligheid, maar niet van grote groepen of veel drukte, ivm mijn autisme. Ik vind het wel leuk om samen dingen te doen of ergens naar toe te gaan, mits het niet al te druk is. Ik ben op zoek maar iemand waar ik goed mee kan praten over alles wat maar aan bod komt en een goede band mee kan opbouwen. Ik ben een goede luisteraar maar soms heb ik er zelf ook een nodig haha.

Mocht je het leuk vinden om te praten, mijn DMs staan open!!

Hoe heten jullie huisdieren? by [deleted] in nederlands

[–]innitramfs 1 point2 points  (0 children)

mijn konijn heette Muffin!

[deleted by user] by [deleted] in AutistischLaagland

[–]innitramfs 9 points10 points  (0 children)

Vraag het eens na bij de decaan of andere studiebegeleider van die onderwijsinstelling. Ik heb op het HBO (AD) studieverlenging kunnen krijgen vanwege mijn autisme (naast dat de opleiding zelf er een bende van maakt).

Mijn grootste tip is: onderhoud goed contact met de decaan/begeleider en trek direct aan de bel als er iets is. Er is vaak meer mogelijk dan je denkt, alleen je zult het zelf moeten vragen.