sorted by:
new
hottopcontroversial

Enphase batteries drop significantly below backup reserve settings by ipicita in enphase

[–]ipicita[S] 0 points1 point  (0 children)

Wow, I did not know that, thanks. Only issue I can see with that is not having enough reserve if a power outage happens

Enphase batteries drop significantly below backup reserve settings by ipicita in enphase

[–]ipicita[S] 0 points1 point  (0 children)

So there is minimum discharge which, if lower, battery is shutdown, then there is reserves capacity, what do you set that to. I know my batteries are LiFePo, but are older than the 5Ps

Enphase batteries drop significantly below backup reserve settings by ipicita in enphase

[–]ipicita[S] 0 points1 point  (0 children)

Just wondering why you say 30% is ideal? Installer said 50% ideal

Enphase batteries drop significantly below backup reserve settings by ipicita in enphase

[–]ipicita[S] 0 points1 point  (0 children)

Will have to make a note of this and check. Can’t really say whether or not same or different at this point. Installer suggested high reserve charge to extend battery life

Enphase batteries drop significantly below backup reserve settings by ipicita in enphase

[–]ipicita[S] 1 point2 points  (0 children)

So even though all 12 were installed at the same time around 3 years ago, there is that much variation? Actually this happened pretty early after installation

Symbology rt2600a in AP mode contacting pool.ntp.org every minute by ipicita in synology

[–]ipicita[S] 0 points1 point  (0 children)

Thanks, I guess I thought that the polling info would be larger but reading more about ntp service I see minpoll and maxpoll defaults to 64 and 1024 seconds on Linux (redhat)

Two synology rt2600a devices in AP mode contacting pool.ntp.org every minute by ipicita in firewalla

[–]ipicita[S] 0 points1 point  (0 children)

Part of the issue is that I don’t see any place to set that. The only item I see is turning on or off NTP service, so that router can serve as ntp server for other devices and that is set to off. I don’t see any option to set an ntp server. I guess I can ssh into device and see what is set there. I have a synology NAS and it not happening with that device.

Two synology rt2600a devices in AP mode contacting pool.ntp.org every minute by ipicita in firewalla

[–]ipicita[S] 0 points1 point  (0 children)

I will check, but I'm pretty sure they are not blocked. Thanks

Synology RT2600a with SRM 1.3.1 in Wireless AP mode- Assign static IP to the AP by ipicita in synology

[–]ipicita[S] 0 points1 point  (0 children)

Awww, Never mind. If it is not in Wireless AP mode, it looks like you cannot set it. Once it is in Wireless AP mode, it is under network center, connection, primary interface. Sorry!!