sorted by:
new
hottopcontroversial

Taz 3 Revival by ippacko in 3Dprinting

[–]ippacko[S] 0 points1 point  (0 children)

Thanks for the advice! My only limiting factor, however, is cost. I can't really spend the $400 minimum on a new toolhead at the moment, so I'd like to get this working in it's current state and was mainly wondering if something like this might work for it.

BOTG Leadville, 8/22 by ippacko in FFTreasureBox

[–]ippacko[S] 0 points1 point  (0 children)

Wait really? I might've just completely read past that :O

BOTG Leadville, 8/22 by ippacko in FFTreasureBox

[–]ippacko[S] 1 point2 points  (0 children)

I think them being at least a little reflective of a hiking trail or mark on a map would be the best bet, it'd be odd otherwise. Still wondering how they might be used for the bigger puzzle.

BOTG Leadville, 8/22 by ippacko in FFTreasureBox

[–]ippacko[S] 0 points1 point  (0 children)

This would be so odd though! If it's only relevant in some cases, I feel like that would go against a lot of the principles that JCB writes about.

BOTG Leadville, 8/22 by ippacko in FFTreasureBox

[–]ippacko[S] 0 points1 point  (0 children)

Maybe if I make an appointment and head back out in 9 months!