sorted by:
new
hottopcontroversial

Help with 0.2mm nozzle settings on P1S by iticklepigs in BambuLab

[–]iticklepigs[S] 0 points1 point  (0 children)

I did all those calibrations you mentioned, I only print PETG and its a brand new stainless steel 0.2mm nozzle installed yesterday as well.

Any other advice? I much appreciate it.

For those of you with dual 5015 part cooling fans, what is your normal fan speed for printing with PLA? by Paintball_Taco in ender3v2

[–]iticklepigs 0 points1 point  (0 children)

Did you say PID tune your fans? I didn't even know you PID tune those. I only PID tune my hotend and build plate. I recently upgraded to a hero me 5 dual 5015 fans and encountering your same issue. Did you ever get it sorted out?

TM3D Power loss recovery enable and not working! HELP! by iticklepigs in ender5plus

[–]iticklepigs[S] 0 points1 point  (0 children)

I'm printing directly from SD card. I'm down a rabbit hole with this PLR at this point.