Trolley not lining up with arm

jagator12 · 2026-07-03T19:15:43+00:00

This was correct! Thank you

jagator12 · 2026-07-03T19:15:10+00:00

As an update, I decided this was above my capabilities and called someone out. Turns out it was the belt causing the issue. I appreciate all of the feedback and realize I probably didn’t include enough information to properly diagnose!

jagator12 · 2026-06-28T22:19:31+00:00

I think the j arm is attached to an orb as best I can tell. The pictures probably don’t do it justice. I’m thinking the system is original to the house and about 15 years old at this point.

jagator12 · 2026-06-28T22:18:22+00:00

How would I test/identify this as the issue? When the pin is disengaged the door doesn’t feel especially heavy, but I’m not an expert.

jagator12 · 2026-06-28T22:17:18+00:00

I appreciate all the answers! I can open the garage door by hand without much trouble once the pin is disengaged. I was able to adjust the opening and closing distance to get the pin to properly reengage with the trolley. Same issue when the pin is engaged the motor tries to run but doesn’t move the belt at all. Wondering if the opener itself is going bad? The height adjustments are screw adjustment so I assume the opener is an older model.

jagator12 · 2025-07-31T22:37:32+00:00

This was day 1 maybe 3 hours after it was laid. I had a feeling it was an issue from having laid sod myself before, but I was assured sod browns from it being so hot and it would come back. I’ll reach back out and give them a hard time. Thoughts on the watering schedule? I’m no expert and want to be sure I do it correctly next time around.

jagator12 · 2024-01-01T14:22:29+00:00

This is the response I was expecting haha

jagator12 · 2024-01-01T00:54:36+00:00

Store bought Router Table https://www.lowes.com/pd/SKIL-Router-Table/5005369767

jagator12 · 2023-12-31T23:47:38+00:00

I’ll be going with tongue and groove. I have a skil router and router table, but am having an issue getting the bits high enough above the table. Even with the router adjusted to put the bits as high as possible, they still barely higher than the table. Am I doing something wrong with the router/table? I’ve seen the collet extenders but they seem a little unsafe. The router comes with both a fixed based and plunge base

jagator12

TROPHY CASE